Desa FVMR18 Owner's Operation And Installation Manual page 9

2. Attach pilot gas line to pilot outlet of gas
control valve and tighten. Connect ther-
mocouple to rear of gas control valve.
See Figure 9. Do not overtighten. If us-
ing propane/LP gas, see Changing Pilot
Orifice, page 10.
3. Install inlet fitting into inlet opening of gas
control valve (see Figure 10). Use thread
sealant on male pipe threads.
4. Place burner pan assembly in center of
fireplace floor. Make sure front of pan
faces the room from which you wish to
control appliance.
5. Thread gas supply fitting to fireplace gas
supply pipe. Adjust to most convenient
position.
6. Install gas connector tube to gas supply
fitting. Carefully shape tube to attach to
adapter fitting. Be careful not to cause
kinks in tube.
f i r e - p a r t s . c o m
7. Test for leaks following instructions under
Testing Burner for Leaks, page 11.
8. Retighten and adjust location of gas con-
trol as necessary. Gas control should be
level, with control rod to the front.
9. Attach cover, provided with log set, to
burner pan using screws provided.
10. Install thermocouple, pilot and ignitor onto
valve cover as shown in Figure 11. Use
the provided screws.
11. Push control rod extension onto "D"
shaped control rod through center hole
in cover.
Pilot and
Line
Figure 9 - Gas Control Valve with
Thermocouple and Pilot
901267-01E
INSTALLATION
Continued
Thermocouple
and Line
Gas Control Valve
www.desatech.com
12. Install control position decal and control
knob making sure to align marks with
correct stop positions of gas control. Pilot
position will allow knob to push in about
1/2". Align decals in pilot position.
Gas Connector
Tube
Inlet
Gas Control
Opening
Valve
Figure 10 - Installing Inlet Fitting and
Gas Connector Tube
Screw
Ignitor
Control
Knob
Control Rod Extension
Figure 11 - Installing Cover, Control
Knob and Piezo Ignitor
Gas
Inlet
Fitting
Thermocouple
Pilot
Valve
Cover
Piezo
Ignitor
9