Table of Contents
Advertisement
Fault
Appliance does not start.
Programme starts automat-
ically.
Appliance stops during the
programme or cuts out.
All LEDs lit up or flashing.
Button on the control panel
is not described and does
not work.
Cause
Appliance door is not closed
properly.
You did not wait until pro-
gramme ended.
Appliance door is not closed
properly.
Power and/or water supply
has been interrupted.
Top basket is pressing
against inner door and pre-
venting appliance door from
being closed securely.
Electronics have detected a
fault.
No function is saved for the
button.
Troubleshooting en
Troubleshooting
Check whether the mains cable is
2.
properly inserted in the socket and
on the rear of the appliance.
Close the appliance door.
▶
→ "Terminate programme",
▶
Page 32
Close the appliance door.
▶
Check the power supply.
1.
Check the water supply.
2.
Check whether the rear panel of the
▶
appliance is being pressed in by a
socket or hose holder that has not
been removed.
Arrange the tableware so that no
▶
parts project beyond the basket
and prevent the appliance door
from closing properly.
Press the main switch button for ap-
1.
prox. 4 seconds.
→ "Controls", Page 15
The appliance is reset and restar-
ted.
If the problem occurs again:
2.
Switch off the appliance.
‒
Pull out the mains plug or
‒
switch off the fuse in the fuse
box.
Wait at least 2 minutes.
‒
Switch on the fuse in the fuse
‒
box or insert the mains plug.
Switch the appliance on.
‒
If the problem occurs again:
3.
Contact customer service.
‒
→ "Customer Service",
Page 52
Not an appliance fault.
▶
49
Advertisement
Table of Contents
