LG Signature SideKick UWD1CW Owner's Manual page 14

14 INSTALLATION
Front-Loading Washer and Pedestal
Washer with Dryer
Hot Water Tap
a
Cold Water Tap
b
Short inlet hose (2 EA)
c
Long inlet hose (4 EA)
d
Front-Loading Washer and Pedestal
Washer with Turbo Steam Dryer
Hot Water Tap
a
Cold Water Tap
b
Short inlet hose (3 EA)
c
Long inlet hose (5 EA)
d
Y-Connector (1 EA)
e
How to Connect the Water Inlet
Hoses
1
Check the fittings and seals. Inspect the
threaded fitting on each hose and make sure
there is a rubber seal
of each hose to prevent leaking.
†
†
†
†
†
in place in both ends
a
2
Connect the water supply hoses.
• Connect the water inlet hoses to the hot
and cold water faucets tightly by hand and
then tighten another 2/3 turn with pliers.
• Connect the blue hose to the cold water
faucet and the red hose to the hot water
faucet.
3
Flush out the inlet hoses.
• After the hoses are connected, turn on the
water faucets and flush out any foreign
substances such as dirt, sand, or sawdust.
• Let the water drain into a bucket, and check
the water temperature to make sure you've
connected the hoses to the correct faucets.
4
Attach the inlet hoses to the back of the
washer.
• Attach the hot water inlet hose
water inlet on the back of the washer.
Attach the cold water inlet hose
cold water inlet on the back of the washer.
• Tighten the fittings securely. Turn on both
faucets all the way and check for leaks at
both ends of the hoses.
to the hot
b
to the
c