Technovision TVS-S1 User Manual page 7

Disconnect the power source before servicing or repairing electrical equipment.
Inspect portable cord-and-plug connected equipment, extension cords, power bars, and
electrical fittings for damage or wear before each use. Repair or replace damaged equipment
immediately.
Always tape extension cords to walls or floors when necessary. Do not use nails and staples
because they can damage extension cords and cause fire and shocks
Use extension cords or equipment that is rated for the level of amperage or wattage that you
are using.
Always use the correct size fuse. Replacing a fuse with one of a larger size can cause excessive
currents in the wiring and possibly start a fire.
Be aware that unusually warm or hot outlets or cords may be a sign that unsafe wiring
conditions exists. Unplug any cords or extension cords from these outlets and do not use until a
qualified electrician has checked the wiring.
Risk of electric shock is greater in areas that are wet or damp. Install Ground Fault Circuit
Breakers (ELCB) as they will interrupt the electrical circuit before a current sufficient to cause
death or serious injury occurs.
Know where the panel and circuit breakers are located in case of an emergency.
Do not touch a person or stabilizer live apparatus in the event of an electrical incident. Always
disconnect the power source first.
The equipment's are delivered duly labelled for the correct identification of any their parts, which combined
with the
Instructions described in this user's manual, allows the end-user to make any operating of both installation
and commissioning, in an easy and ordered way without doubt. When an equipment differs from the one
shown in figures, additional annexes will be edited if they were deemed appropriate or necessary.
Download on technovision official website.
Finally, once the equipment is installed and operative, for future requests or doubts that could arise, it is
recommended to keep the documentation in a safe place with easy access.
3