2.3.1. Warning notes, concerning the installation of ribbon cables Installation - ribbon
cables into the monitor panel
1) The contacting ends of ribbon cables always have to be installed in a straight and precise
180° position to the connector. Each deviation from a perfect contact position will curse
faulty contact and even danger of short circuit
2) The ribbon cable's contacting side always has to correspond to the contacting side of the
connector, concerning the mounting position.
2.4.
Connection – 20pin picture signal cable
Connect the female 20pin connector „Box Side" of the daughter PCB's pre-connected
20pin picture signal cable to the video interface's male 20pin connector.
Version 24.09.2019
All manuals and user guides at all-guides.com
HW CAM(V98) / (V43)
RL4-UCON7-500