Emotiva Airmotiv XS User Manual page 15

AIRMOTIV XS SUBWOOFERS
9. Line Voltage Selector
This switch is used to select the appropriate line voltage for your area.
NOTE: BE SURE TO SET THIS SWITCH TO THE CORRECT LINE VOLTAGE FOR YOUR AREA.
IF YOU FAIL TO DO SO DAMAGE TO YOUR AIRMOTIV XS SUBWOOFER MAY RESULT.
Note: If you change the Line Voltage setting, you should also change the FUSE in the
subwoofer to the appropriate value (fuse values are shown on the rear panel near the fuse
holder).
Note: To change the Line Voltage Selector setting reach through the slot on the clear cover
with a small screwdriver or other pointed tool and slide the switch to the desired setting.
The switch slider will show the value you have selected.
10. IEC Power Cable Receptacle
The IEC Power Cable receptacle accepts any standard IEC power cable. A high quality
commercial power cable is provided with your Airmotiv XS subwoofer.
11. Fuse Holder
To change the fuse in your Airmotiv XS Subwoofer, remove the power cable, then gently
pry the fuse compartment open (the fuse holder opens like a drawer). Replace the fuse with
one of the correct value, replace the fuse drawer, being sure to snap it firmly into place, and
reinsert the power cable.
Note: If the fuse in your subwoofer blows repeatedly without apparent reason, then you
might have an electrical fault in your Airmotiv XS subwoofer, and you should call Emotiva
Technical Support for assistance.
12. AC Power Switch
Use this switch to turn the main AC Power to your Airmotiv XS subwoofer On and Off.
Note: Your subwoofer will only operate if the AC POWER Switch is turned ON. If the AC
POWER Switch is OFF, your subwoofer will NOT operate, and the Power Mode Switch will
have no effect.
Page 9