J-1
ERRORS
SECURENET errors fall into two categories:
EMC/Encryption Key Errors and SECURENET
Option Errors. Error messages are defined as:
"Messages displayed to alert the user to failures
which affect system or test functionality." A
summary
of
EMC/Encryption
SECURENET Option Errors follows.
J-1.1
EMC/Encryption Error Messages
The following errors occur when there has been
an error or failure that prevents encryption
decode or encode from operating correctly. The
probable cause for the error, along with a
recommended solution is presented.
(qwdId: quick, what do I do ?)
KG Hardware Not Installed
KG EMC module not installed on High
Tier board.
qwdId:
Verify that the Encryption Option has
been purchased.
representative.
Encryption Hardware Failure
This message means that one of the
following failures has occurred:
EMC Temperature Violation
EMC Voltage Violation
SPI Failure
SCI Failure
EMC Internal Critical Failure
Irrecoverable Password Failure
ASTRO
Transmit
Failure
APPENDIX J
SECURENET OPTION
ERROR AND WARNING MESSAGES
Key
and
If so, contact sales
Security
Test
SECURENET CFB Transmit Security
Test Failure
SECURENET XL Transmit Security
Test Failure
qwdId:
Perform encrypt reset from the Special
Function window then perform action
again. If the problem persists, contact the
Service Representative.
Warning - External Key Lost
This message is displayed when an EMC
Powerup
occurred. This is most likely due to a
Password Validation Failure and the EMC
has erased any previously stored keys and
passwords as part of the recovery.
qwdId:
If an External Key is required, it must be
reloaded
UUT Test Key Load Failed
An attempt to load a UUT Test Key has
failed.
qwdId:
Make sure radio is attached, correct
algorithm is selected, then retry keyload.
If keyload still fails, perform encrypt
reset from the Special Functions page
and retry.
External Key Load Failed
An attempt to load an External Key has
failed.
qwdId:
Make sure KVL key loader is attached,
correct algorithm is selected, retry
keyload. If keyload still fails, perform
J-1
Configuration
Failure
has