General Dynamics R2600 Series Operator's Manual page 358

 WUID
 WGID
 RFSS ID
 SITE ID
4. Press the RF Cursor Zone hardkey to
move to the RF zone.
5. Press the 800 MHz softkey to select the
800 MHz band. Move the cursor to the
"CCTx field and enter either the control
channel transmit frequency or the channel
number.
6. Set the monitor attenuation and port
selection. Suggested port selection is RF
I/O with 20 dB attenuation.
7. Set the generator attenuation and port
selection. Suggested port selection is RF
I/O with –50 dB for the level setting.
8. Press the AUD Cursor Zone hardkey to
move the Audio zone.
9. Set the PROJ 25 deviation. The default
and suggested deviation is 2.83 kHz.
10. Connect the radio under test to the RF I/O
port as shown in figure 24-8.
11. Press the DISP Cursor Zone hardkey to
move to the Display zone.
12. Move the cursor to the "Meter" field and
press the start test softkey to begin the
test.
13. Observe the user prompts displayed
above the row of softkeys. Turn radio on
as directed by the prompt.
14. Follow the call sequence by looking at the
sequence thermometer in the middle of
the screen.
The status below the sequence thermometer
gives a textual description of the Call State.
For a description of all call states, refer to
Appendix M.
If the call is successful, the thermometer will
reach 8 and the test is completed. The bottom
portion of the Display Zone will exhibit those
parameters received from the radio.
25-4.2 Dispatch Voice
Select the PROJ 25 TRUNK mode by placing
the cursor in the "Mode" field in the Display
Zone located at the top of the screen.
1. Press the PROJ 25 TRK softkey to select
the mode.
2. Move the cursor to the "Meter" field by
pressing the TAB key.
3. Press the DISPTCH VOICE softkey to
select the Dispatch Voice test.
4. Enter the parameters listed below. If the
parameters are not known, the radio
codeplug must be read using Radio Service
Software (RSS).
WACN ID and SYSTEM ID are required
for communication with the radio under
test. The remaining parameters are
optional unless the radio has been
configured for specific modes of operation.
 WACN ID
 SYSTEM ID
 WUID
 WGID
 RFSS ID
 SITE ID
5. Press the RF Cursor Zone hardkey to move
to the RF zone.
312
NOTE