Connecting Cable To Legacy Display Using Adaptor Cable - Raymarine DRAGONFLY Ice Fishing Kit Installation Instructions Manual

Connecting Cable To Legacy Display Using Adaptor Cable

Adaptor cable A80331 is required to connect an ice fishing transducer to a legacy Dragonfly® display
that utilizes the one keyway Red connector.
1. Connect the adaptor cable's power cable to the battery as follows:
i. Connect the Red (positive) wire to the battery's positive terminal.
ii. Connect the Black (negative) wire to the battery's negative terminal.
iii. Connect the Black/Gray earth wire to the battery's negative terminal.
2. Connect the adaptor cable to the transducer as follows:
i. Rotate the adaptor cable's connector locking collar to the unlocked position.
ii. Ensure correct orientation of both connectors.
iii. Insert the transducer connector into the adaptor cable connector.
iv. Rotate the locking collar clockwise 2 clicks, until in the locked position.
3. Connect the adaptor cable to the display as follows:
i. Rotate the display's connector locking collar to the unlocked position.
ii. Rotate the adaptor cable's connector so that the word 'TOP' is pointing upwards.
iii. Push the cable connector all the way in, the tip of the arrow should be close to the locking
collar.
iv. Rotate the locking collar clockwise 2 clicks, until in the locked position.
Connections