4.1 Connecting the cable to the display
With the suppression ferrite and float fitted to the transducer cable, follow the steps below to connect
the transducer cable to your display.
1. Rotate the display's connector locking collar to the unlocked position.
2. Rotate the cable connector so that the word 'TOP' is pointing upwards.
3. Push the cable connector all the way in, the tip of the arrow should be close to the locking collar.
4. Rotate the locking collar clockwise 2 clicks, until in the locked position.
Important:
Do NOT rotate the cable connector once it has entered the display connector as this could
damage the connector pins.