Dmx Modes; Focus - Iridium 113777 Manual

DMX Modes

DMX512 Channel table
Channel
CH1
Channel
CH1
CH2
Channel
CH1
CH2
CH3
6. Fuse Replacement
If the fine-wire fuse of the device fuses, only replace the fuse by a fuse of same type and rating. Before replacing the
fuse, unplug mains lead.
Procedure:
Step1: Unscrew the fuse holder on the rear panel with a fitting screwdriver from the housing (anticlockwise).
Step 2: Remove the old fuse from the fuse holder.
Step 3: Install the new fuse in the fuse holder.
Step 4: Replace the fuse holder in the housing and fix it.

7. Focus

The objective lens cylinder is usually shrinked before leaving factory, after connect the projector to the mains, user may
loose the screws and pull out the lens cylinder, till the white light output circular is clearly presented, locking tightly the
two screws again.
When the projection distance is changed, user can follow previous operating steps, and focus the projector.
1 Channel Table
Value
Dimmer
2 Channel Table
Value
Dimmer
DimmerFine
3 Channel Table
Value
Dimmer
DimmerFine
Strobe
Rate
0-255 Dimmer, brightness from 0%
Rate
0-255 Dimmer, brightness from 0%
0-255 Brightness micro adjustment
Rate
0-255 Dimmable,brightness from 0%
0-255 Brightness micro adjustment
0-10 Strobe off, 11-255 Strobe frequency(from
0-255
Function
Function
Function
slow to fast)
7