QRS PNO3 User Manual page 45

Pin Light Port Extender (PLx) LED Light Status and Start Up
Light #1
Power/Status
Light #2
System Activity
Light #3
Network Status
QRS Music Technologies, Inc.
QRS Pno
Green Solid Power to the solenoid rail is on, the High Power light on the power
supply is on, system is ready to be played.
Green Blink MIDI Control Data is being sent to the piano as a PWM signal. The
Piano should be playing
Amber Solid The piano is in Stand By Mode, power to the solenoid rail is off, the
High Power light on the power supply is off, the piano is awaiting a
signal to wake up before playing.
Amber Blink N/A
Red Solid There is a Key Solenoid or Pedal Solenoid Over-Current status which
will shut the high power to the system down.
Red Blink N/A
Green Solid The Pin Light Port Extender (PLx) has initialized, the controller under
the piano has successfully initialized, and the low power light is on
the power supply.
Green Blink N/A
Amber Solid N/A
Amber Blink The light will wink at you if the system is receiving an IR control
signal
Red Solid There is a power issue/failure on the solenoid rail
Red Blink N/A
Green Solid The system is in Stand-Alone Mode, which means it is acting as a
router (hands out IP addresses) and belongs to its own network
(QRSPNOxxx)
Green Blink The system is setup to be in Stand-Alone Mode but there is no net-
work device or cable connected.
Amber Solid The system is in Network Mode but there is no network device or
cable connected
Amber Blink The system is in Network Mode but there is no network device or
cable connected
Red Solid No Network Connected
Red Blink Trying to find a network
User Guide
3
45
Technical Support - 800-247-6557
www.qrsmusic.com