QRS PNO3 User Manual page 44

Pin Light Port Extender (PLx) LED Light Status and Start Up
Start Up
Operating
System
Updating
Button Push
QRS Music Technologies, Inc.
QRS Pno
Start Up Sequence
Voice Prompts (light 6
blinks amper)
Start Up Sequence
Complete
To Hear Status Again
Plus your systems serial
number
Green
Lights Gradually Light
Up from Right to Left
Voice Prompts
Button Push
Button Push 4 to 6 sec
Botton Push > 16 sec
User Guide
3
On Power Up—Lights cycle from Left To Right each Light
Winks and Cycle through each of its potential colors
1. Welcome to Pianomation
2. Operating Software Version Announced
3. Announces Your System Is Ready
4. Announces if a Network Cable is Detected
5. IP Address Announced
Lights will indicate their status (ref other pages —)
Using the IR Remote pointed at the IR receiver (button on
PLx): Select Shift (let go) then 3 (let go) or
Hold PLx button down for 4 to 6 seconds
PNOscan optical record sensor strip is connected
All lights gradually light up based on update completion
percentage, all lit at completion, then reboot
1. Update
2. Please do not remove media or disturb power until
update is complete
3. Update in Progress (depends on size of update)
4. Update Complete
5. (system now reboots and you will lose connection)
6. Voice Prompts will follow the start up prompts
Starts and stops playback of the default playlist you have set
Voice Prompt Information
Reboots piano first 3 lights turn amber and last light is red
44
Technical Support - 800-247-6557
www.qrsmusic.com