Charger Mounting; Checking The Charger - Briggs & Stratton EBSB2AH82 User Manual

EN
AR BG CS DA DE EL ES
False Defect Note:
When the battery is inserted into the charger,
and the status LED flashes, remove the
battery from the charger for 1 minute, then
reinsert. If the status LED indicates normal
than the battery pack is good. If the status
LED is still blinking, remove the battery pack
and unplug the charger. Wait 1 minute and
plug the charger back in and reinsert the
battery pack. If the status LED indicates
normal than the battery pack is good. If the
status LED is still blinking then the battery
pack is defective and needs to be replaced.
NOTE: When the red indictor flickers, pull out
the battery from the charger and insert again
within 2 hours. If the indictor shows charging,
that means the battery is good. After 2 hours,
please pull out the battery and also pull
out the AC power plug of the charger for 1
minute, and then insert the AC power plug
and the battery again. If the indictor shows
charging, that means the battery is good. If
not, the battery needs to be changed.

CHECKING THE CHARGER

If the battery pack does not charge properly:
„ Check the current at the power outlet
with another tool. Make sure that the
outlet is not turned off.
„ Check that the charger contacts have not
been shorted by debris or foreign material.
„ If the surrounding air temperature is not
normal room temperature, move the
charger and battery pack to a location
where the temperature is between 6 ˚C
and 40˚C.
WARNING
If the battery is inserted into the charger
when warm or hot, the CHARGING LED
indicator light on the charger may switch
on and illuminate RED. If this occurs
allow the battery to cool outside of the
charger from approximately 30 minutes.
ET FI FR HR HU IT LT LV NL NO PL PT RO RU SK SL SV TR
English (Original instructions)

CHARGER MOUNTING

1. This charger can be installed hanging on
a wall using two #8 screws (not supplied).
2. Locate the placement for the charger to
be wall mounted.
3. If fastening to wood studs use 2 wood
screws (not included).
4. For Charger EBSRC82: Drill two holes
on center 114mm apart ensuring that
they are vertically aligned.
For Charger EBSSC82: Drill two holes
on center 101.6mm apart ensuring that
they are vertically aligned.
5. If fastening to drywall use wall anchors
(not included) and screws to secure the
charger to the wall.
NOTE: If the battery and the charger won't
be used for a long time, please remove the
battery from the charger and pull out the
AC power plug.
5