ABB CP3200 Quick Start Manual page 3

QUICK START GUIDE
Testing for The Presence of DC Voltage:
Using your multi-meter set for DC voltage, measure for the presence of DC voltage between the following:
•
Between Tip and Ring
•
Between Tip and Ground
•
Between Ring and Ground
Note: If voltage is present on any of the preceding measurements for each cable pair, note that cable pair in the
following table 1. That DC fault must be cleared to proceed in using that cable pair.
Adjust the meter to read DC voltage and carefully connect the multimeter leads to the RING and TIP terminals for
each cable pair connection. If any DC voltage is measured, record the data in Table 1.
Adjust the meter to read DC voltage and carefully connect the multimeter leads to the RING and GROUND terminals
for each cable pair connection. If any DC voltage is measured, record the data in Table 1.
Adjust the meter to read DC voltage and carefully connect the multimeter leads to the TIP and GROUND terminals
for each cable pair connection. If any DC voltage is measured, record the data in Table 1
Page 3
© 2021 ABB. All rights reserved.