Regin DTB5/5 Instructions

EN INSTRUCTION
DTB...
IN20009 REV. G, 2021-05-17
C C a a u u t t i i o o n n ! ! Read and understand the instruction before using the product.
C C a a u u t t i i o o n n ! ! Ensure that the installation complies with local safety
regulations.
C C a a u u t t i i o o n n ! ! Before installation or maintenance, the power supply should first
be disconnected. Installation or maintenance of this unit should only be
carried out by qualified personnel. The manufacturer is not responsible
for any eventual damage or injury caused by inadequate skills during instal-
lation, or through removal of or deactivation of any security devices.
Technical Data
Supply voltage 24 V AC/DC (18...30 V AC/DC)
Output signal 0...10 V / 4...20 mA
Display Yes
Display type LED, 4 digits
Sensor element, pressure Piezo-resistive pressure sensor
Accuracy, pressure ±1 % full scale, min. ±1 Pa
Power consumption < 6 W
Load impedance, 4...20 mA 20...500 Ω
Load impedance, 0...10 V ≥ 1 kΩ
Protection class IP54
Ambient humidity 0...95 % RH (non-condensing)
Ambient temperature -10...+50 °C
Response time 100 ms / 1 s
Storage temperature -10...+50 °C
Media Air and non-corrosive gases
Zero-point adjustment Automatic
Cable connection Screw terminals max. 1.5 mm²
Cable gland M16
Pressure connection Connection pipes for 6 mm tube
Mounting Wall
Accessories, included Two pressure outlets (cut 60°) and 2 m
plastic tube. Art. no.: ANS-1
Dimensions, external (WxHxD) 85 x 85 x 58 mm
Models
Article Measuring range,
pressure
DTB5/5 -50...+50 Pa
DTB10/10 -100...+100 Pa
DTB125 0...100 Pa / 0...250 Pa
DTB510 0...500 Pa / 0...1000 Pa
Installation
The unit can be mounted in any position as the automatic calibration
eliminates any position error.
Wiring
4
3
2
L
1
Figure 1 Terminal assignments (L= Load)
DTB...
Terminal
4
3
2
1
Settings
Jumpers are available for changing the output signal and its response
time as well as selecting the pressure range (on models where this is
possible).
Max. overload pressure
60 kPa
60 kPa
60 kPa
75 kPa
Number
1
2
3
4
Handling
The transmitter regularly performs automatic zero-point adjustments,
which means that no manual calibration is needed.
Description
Not used
Ground GND
Output signal
Supply voltage
Function Jumper on Jumper off
Pressure range Low High
Response time Slow Fast
Not used - -
Output signal 0...10 V 4...20 mA
1
2
3
4
1