Advertisement
FAQ:
1. How to restore factory settings?
Select "Setting"→"Backup&reset"→"Factory date reset"
2. Can't start PDA?
(1) If the new device does not turn on, please make sure the sticker on
battery has been removed.
(2) Pressing the power button need about 4s, so press the power
button untill the screen showing contents.
(3) Check the if the battery have power, put the battery to PDA and
charge it, if the screen shows charging icon, charge the PDA for some
time and restart it.
3. PDA can not connect to PC?
When the PDA is connected to a PC but no prompt message appears,
try a different cable. If nothing occurs, try a different PC.
4. When useing scanner,there is no data but scan-light on, Why?
(1) Go to scan setting, and check "keyboard output".
(2) If checked, then please reset the scan demo for twice, and operate
"OFF"--"ON".
5. The device cannot scan the code.
(1) Check each scan button can be used normally.
(2) Check the scan engine supports the bar code.
(3) Check the scanning lens and bar code is clear and unobstructed.
(4) Check the scan setting and reset.
6. The device does not charge.
(1) Check the device adapter and charging port are good.
(2) If the device is not used for a long time, please keep it charged for
30 minutes. Then check the device lights on or not.
(3)Replace the battery of the device that can be turned on normally,
check the problem on battery or device.
7. How to use the battery correctly?
The battery is Li-on, If there is no power, please charge immediately,
do not leave the battery with full power or no power for long periods of
time. The best way to store the battery is with 50% power in it. If you
don't use the PDA for long periods of time, please remove battery from
PDA and store it.
10
Advertisement
