Advertisement
Installation
Grounding
In order to attach the green-yellow
grounding cable to the camera, perform
the following:
Remove the pre-installed M4 x 6mm screw
from the indicated grounding point.
Replace the nylon washer with a knurled
washer (not included) and align the ring
terminal of a 20AWG or larger grounding
cable with the grounding point on the back
of the device. Drive the M4 x 6mm screw
through the washer and terminal into the
grounding point on the back of the device.
Attach the other terminal of a grounding
cable directly to a circuit breaker, ground
rod or earth ground.
This unit is powered by PoE through a UL
Listed ITE.
15
Verkada Inc. 405 E 4th Ave, San Mateo, CA 94401
sales@verkada.com
Grounding
All specifications are subject to change without notice
Copyright © Verkada Inc. All rights reserved.
Advertisement
