CNET CWP-905 User Manual page 42

Direct Link
Setup Enable
MAC Address
Timeout Value
Tear Down
After you finish the settings, click 'OK' to close configuration utility.
Enable or disable direct link setup (DLS) function.
This function will greatly improve the data transfer rate between
WMM-enabled wireless devices. Please click 'Apply' button on the
right of this check box after you check or uncheck this box, so
corresponding settings in this window will be activated or
deactivated respectively.
Input the MAC address of another WMM-enabled
wireless device you wish to establish a direct link here, then click
'Apply' to add this MAC address to DLS address table.
Input the timeout value of this WMM-enabled direct link wireless
device. If the wireless device is not responding after this time, it will
be removed from DLS table.
If you want to remove a specific wireless device from DLS table,
select the device and click this button to remove it.
42