CNET CWP-905 User Manual page 36

Wireless-n pci adapter
Hide thumbs Also See for CWP-905:
Table of Contents

Advertisement

every item:
Status
Extra Info
Channel
Link Speed
Throughput
Link Quality
Signal Strength 1
Signal Strength 2
Noise Level
dBm
There are several wireless statuses available at the bottom of this window.
For their explanations, please see chapter 4-3 'Glossary'.
Display the SSID and BSSID of connected wireless access point or
wireless device (displayed as SSID <-> BSSID as shown in above
picture. If there's no active connection currently, 'Disconnected'
will be displayed here.
Displays the link status ('Link is up' or Link is down', and the radio
transmitting power of your network card.
Displays the radio channel being used now.
Displays the link speed of data transmitting (Tx, in Mbps) and
receiving (Rx, in Mbps). Link speed is the maximum available data
transfer speed of the wireless connection, and depends on the
radio signal quality of wireless connection.
Displays the rate of data transmitting (Tx, in Kbps) and receiving
(Rx, in Kbps).
Displays link quality (radio signal quality). When the link quality is
better, the wireless link speed will be better, too. Link quality is
displayed by percentage and a descriptive word (Good, normal,
weak, and low).
Displays the radio signal strength of built-in antenna 1.
Displays the radio signal strength of built-in antenna 2.
Displays the percentage or level of noise (unusable) signal. If the
value of this item is high, data transfer rate will drop.
Check this box and the value of signal strength and noise level will
be displayed in dBm level instead of percentage.
36

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents