Advertisement
Quick Links
Advertisement
Related Manuals for VELOWAVE PONY
Summary of Contents for VELOWAVE PONY
- Page 1 Instructions to Set Up Your VELOWAVE PONY Diagram 1 / 16...
- Page 2 We know you are excited about getting going but please: ✓ Reseat and charge the battery before the first ride ✓ Make sure the pedals are tight ✓ Make sure the front wheel is installed properly and tight ✓ Inflate the tires properly ✓...
- Page 3 Assembling Your E-Bike 1) Read all of the instructions carefully. Be familiar with the proper operation of all items. 2) This quick guide is intended to list the steps needed to assemble your bike with some mechanical skills. It is not a complete manual or training. If you do not feel comfortable or lack some of the skills to assemble it yourself, reach out to a cyclist friend, a local bike mechanic or one of our support technicians for guidance.
- Page 4 Installing Your Handlebars 1) Place the handlebar in the handlebar mount being careful with the wires. 2) Face the mounting brackets on the front end of the mount with the round edges facing outward. Adjust the handlebar angle to your comfortable riding posture. 3) Secure the mounting brackets with four screws.
- Page 5 Installing Your Front Wheel 1) Insert the axle into the wheel hub as shown. Add the Slim Spacer on the LEFT side (Brake Disk), the Wide Spacer and one washer on the RIGHT side. 2) Insert the front wheel in between the front fork on the bike. Be sure to align the disc between the brake caliper as shown in Figure 2.
- Page 6 Installing Your Front Fender and Headlight 1) Place the headlight bracket in front of the fork gantry. Put the fender’s top bracket behind the fork gantry. Thread the screw in sequence through the headlight bracket, the fork gantry and the fender bracket and secure with a washer and screw nut. 2) Connect the headlight cable with the wire coming out from the downtube.
- Page 7 Installing Your Pedals 1) Warning: Incorrect installation will cause damage. Please read the instructions and watch our videos if needed. 2) Identify the Left and Right markings on the pedals. They can only be installed in their respective side. a. L is for the Left Pedal and it goes on the Left Crank Arm. b.
-
Page 8: Preparations Before Riding
Preparations Before Riding 1) Read all instructions carefully, be familiar with the proper operation of all items. Check for detailed information and guidance on our product page. 2) Warning: Basic electric precautions should always be followed to avoid issues or malfunction. Installing and Removing the Battery To Install the Battery 1) Turn the key counterclockwise to release the lock. - Page 9 To Remove the Battery 1) Turn off the LCD display. 2) The battery is secured with a double-lock mechanism. Use the key to release the first lock. Push slide the plastic tab under the tube to release the second lock. Note: Please hold the battery tight with one hand at least as it will drop off when the lock is released.
- Page 10 How to Use the Display 1) Power on/off Press the button to turn on the display. Your bike will be ON. Press again to turn it off. The display will automatically shut down when there is no operation or riding for 5 minutes. 2) Adjust the assist level Short press “+”...
- Page 11 How to Charge Your Bike There are two ways to charge your battery. 1. Charge the battery ON the bike 1) Find the Charge Port at the bottom of the downtube. 2) Pull out the cover to show the charge port and insert the charger output plug into the port. Connect the input plug to the power supply.
- Page 12 Do not leave a charging battery unattended. Never charge a battery for more than 12 hours at a time. Failure to follow battery charging best practices could result in unnecessary wear to the charging components, battery, and or charger, and could lead to an under-performing or non-functional battery and replacement will not be covered under warranty.
-
Page 13: Error Code
Error Code Error Code Error Notes Brake is in braking state. Check and make sure the brake lever is Braked not stuck at braking. Change the brake lever if it doesn’t recover. Throttle has not returned to the start-up position. Check if the Open Throttle Fault throttle gets stuck. -
Page 14: Basic Troubleshooting
Basic Trouble Shooting SYMPTOMS CAUSES SOLUTIONS ⚫ ⚫ Battery off Turn on battery ⚫ ⚫ Battery installation Reseat battery ⚫ ⚫ LCD display not on Turn on LCD display Throttle and pedal assist not working ⚫ ⚫ Discharged battery Charge battery ⚫... - Page 15 Label of Your VELOWAVE 15 / 16...
- Page 16 To find out more, please visit our website at www.velowavebikes.com 16 / 16...