Step 1 - Unpack The Hotline; Warmer; Step 2 - Clamp The Hotline  3 Warmer To The I.v. Pole - Smith Medical LEVEL 1 HOTLINE 3 HL-390-38 Operator's Manual

S E C T I O N 4
SECTION 4
Assembly Instructions
Read through the instructions completely prior to setting up the

HOTLINE

3 Warmer.

Step 1 - Unpack the HOTLINE

1 Open the shipping carton and remove the HOTLINE
2 Check the contents of the package to verify the following
components are present:

• HOTLINE 3 Warmer
• Operator's Manual

• HOTLINE 3 Inspection/Test Form
3 Examine the HOTLINE
appear damaged, do not use the HOTLINE
Smiths Medical for a replacement.
Note: After unpacking the HOTLINE
material according to hospital policy for recyclable materials.
Step 2 - Clamp the HOTLINE
Pole
• Ensure that the HOTLINE
tightly onto the I.V. pole. Failure to securely mount the
®
HOTLINE 3 Warmer onto the I.V. pole may cause the
®
HOTLINE 3 Warmer to slide down the pole and may injure the
patient or user.
• Do not mount the HOTLINE
above the floor. For convenience, 107cm (42") is indicated on
®
the HOTLINE 3 Warmer line cord by a black mark. Mounting
®
the HOTLINE 3 Warmer above 107cm (42") may result in
instability of the pole and tipping that may injure the patient or
user.
• This device is cooled by convection. Be sure the air vents on the
bottom and the back of the device are kept clear.
®
HOTLINE 3 Blood and Fluid Warmer | Operator's Manual
• A s s e m b l y I n s t r u c t i o n s

3 Warmer

3 Warmer for damage. If any components

3 Warmer. Contact

3 Warmer, recycle packaging
 
3 Warmer to the I.V.
WARNINGS
WARNINGS
®
3 Warmer pole clamp is screwed
®
3 Warmer more than 107cm (42")
CAUTIONS

3 Warmer.
9