Advertisement
Quick Links
Instructions for disassembly - DOMEO 210 FL 3V EU
1. General notes
Instructions manual for disassembly and ecologically disposal of components of ventilation units according to
EU 1253/2014.
This manual includes the disassembly of the ventilation unit into material fractions and larger components.
2. Safety instructions
Attention!
•
Observe the assembly instructions of the product and ensure compliance with all safety specifications.
•
Cut off the electrical supply before any work begins.
3. Parts to be disassembled
The following parts should be disassembled:
•
Counter-flow heat exchanger
•
Unit body (large plastic part)
•
Panels/covers
•
Control equipment (wiring and electronic components)
•
Supply fan
•
Extract fan
•
Supply motor
•
Extract motor
•
Air connections
•
Filters
•
By-pass motor
•
Small metal pieces (supports and screws)
4. Procedure and tools needed for disassembly
The following tools are required for disassembly of the ventilation unit: Scissors, Nippers, Pliers, Phillips
screwdriver, allen screwdriver.
1. Remove filter cover (plastic) and filters by
hand. Filters should be put on general waste
bin.
www.solerpalau.com
2. Remove the 4 air connections by hand.
Advertisement
Related Manuals for S&P DOMEO 210 Series
Summary of Contents for S&P DOMEO 210 Series
- Page 1 Instructions for disassembly - DOMEO 210 FL 3V EU 1. General notes Instructions manual for disassembly and ecologically disposal of components of ventilation units according to EU 1253/2014. This manual includes the disassembly of the ventilation unit into material fractions and larger components. 2.
- Page 2 3. Remove the two bottom screws by a phillips 4. Pull from the heat exchanger and separate screw driver and remove the front cover it from the main body. (plastic) by hand. 5. Remove the two fan covers. Disconnect the 6.
- Page 3 4.1. Disassembly of heat exchanger Cut the heat exchanger’s grip using scissors and remove the metal supports by hand. 4.2. Disassembly of fan-motor Use a phillips screwdriver to unscrew the two screws that join the scroll of the fan. Then, unscrew the three screws that unite the scroll to the motor.