Hints And Tips - AEG TR9W75680 User Manual

24 www.aeg.com
After setting a drying programme, the
if the programme supports it.
Touching the Start/Pause button, the
ProSense starts the laundry load
detection:
1. The appliance detects the load in the
first minute: the indicator flashes, the
bars under the icon move back and
forth
shortly.
2. When the drum stops rotating, the
display shows the new programme
duration adjusted according to the
detected load. The number of bars,
from 1 to 4, represents the estimated
load amount. 4 bars represent the
maximum load amount for the
selected programme.
In case of drum overload,
the maximum declared load
indicator comes on again
with the
blinking. In this case, during
these 30 seconds, it is
possible to open the door
and remove the exceeding
garments. Once removed,
touch the Start/Pause button
to start the programme
again. If the laundry amount
will not be reduced, the
programme starts anyway.
In this case, it will be not
possible to guarantee the
best results.
9.11 Program change
To change a program:
1. Push the Ein/Aus button to turn the
appliance off.
2. Push the Ein/Aus button again to turn
on the appliance.
3. Set a new program.

10. HINTS AND TIPS

10.1 Ecological hints
• Spin the laundry well before drying.
icon lights up on the display
and the drum rotates
indicator
9.12 Programme end
Clean the filter and drain the
water container after each
drying cycle. (See chapter
CARE AND CLEANING.)
If the drying cycle is finished, the symbol
appears on the display. If the Signal
option is activated, the acoustic signal
sounds intermittently for 1 minute.
If you do not turn off the
appliance, the anti-crease
phase starts (not active with
all programmes). Flashing
symbol signals the
execution of the anti-crease
phase. Laundry can be
removed during this phase.
To remove the laundry:
1. Push the Ein/Aus button for 2
seconds to turn the appliance off.
2. Open the appliance door.
3. Remove the laundry.
4. Close the appliance door.
Possible causes of unsatisfactory drying
results:
• Inadequate default dryness level
settings. See chapter
default dryness level
• Room temperature is too low or too
high. Optimal room temperature is
between 18°-25°C.
9.13 Drum light on
Touch and hold down Leise button by
around 3 seconds.
The light inside the drum is on.
• Do not exceed the load sizes which
are specified in the programmes
chapter.
Adjustment of