Hints And Tips - AEG TR73CB96 User Manual

9. HINTS AND TIPS

9.1 Ecological hints
Loading the drum up to the maximum
capacity indicated for the respective
programmes will contribute to the energy
saving.
• Spin the laundry well before drying.
• Do not exceed the load sizes which are
specified in the programmes chapter.
• Clean the filter after each drying cycle.
• Do not use fabric softener to wash and
then dry. In the tumble dryer laundry
becomes soft automatically.
• The water from the water container can be
used to iron the clothes. You must first
filter the water to eliminate remaining
textile fibres (simple coffee filter is
suitable).
• Always keep the airflow slots at the bottom
of the appliance clear.
• Make sure there is good airflow where the
appliance is to be installed.
9.2 Adjustment of default dryness
level
To change the default dryness level:
1. Turn the appliance on.
2. Select 1 of the available programmes.
3. Touch and hold down the Dryness Level
and End Signal buttons at the same
time.
One of the symbols appears on the display:
- Maximum dryness
- Extra dryness
- Standard dryness
4. Touch the Start/Pause button repeatedly
until you reach the desired dryness level.
Dryness level
Maximum dry‐
ness
Extra dryness
Display symbol
Dryness level
Standard dry‐
ness
5. To memorise the setting touch and hold
down the Dryness Level and End Signal
buttons at the same time for
approximately 2 seconds.
9.3 Deactivating the water container
indicator
The water container indicator is activated by
default. It illuminates at the end of the drying
cycle or during the cycle if the water reservoir
is full. If the draining kit is installed the water
container is drained automatically and the
indicator can be deactivated.
To deactivate the indicator:
1. Turn the appliance on.
2. Select 1 of the available programmes.
3. Touch and hold down Anti-crease and
End Signal buttons at the same time.
The water container indicator:
the symbol
container indicator is permanently
deactivated
To activate the water container indicator
back, follow the above procedure again.
The water container indicator:
and the symbol
water container indicator is permanently
activated
9.4 Operating hours counter
This function gives a possibility to display the
total operating time of the appliance in hours,
which is counted from the moment it is first
switched on. The actual operating time of the
cycles is shown (does not include pauses or
delayed start time).
To visualise this value, proceed as follows:
1. Switch the appliance on by pressing the
On/Off button.
Display symbol
is off and
appears - the water
is on
appears - the
ENGLISH 19