Natural Gas Conversion - KitchenAid KSDG950ESS2 Installation Instructions Manual

Slide-in downdraft ranges
Table of Contents

Advertisement

Complete Installation (Natural Gas to Propane Gas)
1. Refer to the "Make Gas Connection" section for proper
connection of the range to the gas supply.
2. Refer to the "Electronic Ignition System" section for proper
burner ignition and operation.
3. Refer to the "Adjust Flame Height" section for burner flame
adjustments.
IMPORTANT: You may have to adjust the low setting for
each cooktop burner.
Checking for proper cooktop burner flame is very important.
Natural gas flames do not have yellow tips.
4. Refer to "Complete Installation" in the "Installation
Instructions" section of this manual to complete this
procedure.
IMPORTANT: Make sure to save the orifices that have
just been replaced in the conversion.

Natural Gas Conversion

WARNING
Tip Over Hazard
A child or adult can tip the range and be killed.
Install anti-tip bracket to floor or wall per installation
instructions.
Slide range back so rear range foot is engaged in the
slot of the anti-tip bracket.
Re-engage anti-tip bracket if range is moved.
Do not operate range without anti-tip bracket installed
and engaged.
Failure to follow these instructions can result in death
or serious burns to children and adults.
1. Turn manual shut-off valve to the closed position.
A
A. To range
B. Shut-off valve (closed position)
C. Gas supply line
2. Unplug range or disconnect power.
24
To Convert Gas Pressure Regulator
(Propane Gas to Natural Gas)
1. Move the range out from the wall.
2. Locate the gas pressure regulator at the lower right corner
on the back of the range.
IMPORTANT: Do not remove the gas pressure regulator.
3. Remove the front lower panel of the range.
4. Disconnect the blower motor electrical connections.
5. Disconnect the downdraft blower bellows from the range.
6. Unscrew the metal cover and unscrew the blue regulator
cap. Keep the washer in place.
7. Flip the blue regulator cap over and screw it back into
the metal cover.
B
8. Screw the metal cover securely back into place.
Do not overtighten.
A. Gas pressure regulator
A
A. Metal cover
B. Washer
C. Blue regulator cap
A
A. Propane gas position
B. Natural gas position
A
A
B
C
B

Advertisement

Table of Contents
loading

Table of Contents