Advertisement
Advertisement
Table of Contents
Related Manuals for Konquest KDT-1201
Summary of Contents for Konquest KDT-1201
- Page 1 KDT-1201 QUICK USER GUIDE KONQUEST KDT-1201 ORAL - ARMPIT - RECTAL THERMOMETER...
- Page 2 PRODUCT STRUCTURE [1] Power button [2] LCD display screen [3] Probe [4] Battery cap BATTERY REPLACEMENT Figure 1 Figure 2 Figure 3 1. Replace battery when “ ”appears in the lower right corner of LCD display. 2. Pull battery cover off as shown in Figure 1. 3.
- Page 3 DIRECTIONS [1] Press the On/Off Button next to LCD display. A tone will sound as the screen shows , followed by last recored temperature. After showing the self-test temperature, the thermometer is now in the testing mode. *Note: If the measured temperature is less than 90˚F or 32˚C , the LCD will display Lo, if the measured temperature is higher than 109.9˚For 42.9˚C, the LCD will display Hi.
- Page 4 [3] The degree sign flashes throughout the testing process. When flashing stops an alarm will beep for approximately 10 seconds. The measured read- ing will appear on the LCD simultaneously. The minimum measurement time until the signaling tone (beep) must be maintained without exception. The measurement continues even after the buzzer notification.
Need help?
Do you have a question about the KDT-1201 and is the answer not in the manual?
Questions and answers
KDT 1201 thermometer does not beep. New.
The Konquest KDT-1201 thermometer does beep, but the 10-second beep is not the final reading. It beeps after about 10 seconds to indicate a preliminary result, but for an accurate and stable temperature, it must stay in place for about 2 minutes. The early beep is part of its programming and does not mean the measurement is complete.
This answer is automatically generated