Konquest KDT-1201 Manual

INSTRUCTION M ANUAL
Warning :
Read instructions thoroughly before using digital thermometer.
Choking Hazard: Thermometer cap and battery may be fatal if swallowed. Do not allow children
to use this device without parental supervision.
Do not use thermometer in ear. Designed use is for oral, rectal, and armpit (axilla) readings only.
Do not place thermometer battery near extreme heat as it may explode.
Note: Use of the probe cover may result in a 0.2℉(0.1℃) discrepancy from actual temperature.
It is recommended the performance should be checked every two years.
Remove battery from the device when not in operation for a long time.
The use of temperature readings for self-diagnosis is dangerous. Consult your doctor for the
interpretation of results. Self-diagnosis may lead to the worsening of existing disease conditions.
Do not attempt measurements when the thermometer is wet as inaccurate readings may result.
Do not bite the thermometer. Doing so may lead to breakage and/or injury.
Do not attempt to disassemble or repair the thermometer. Doing so may result in inaccurate readings.
After each use, disinfect the thermometer especially in case the device is used by more than one person.
Do not force the thermometer into the rectum. Stop insertion and abort the measurement when pain is
present. Failure to do so may lead to injury.
Do not use thermometer orally after being used rectally.
For children who are two years old or younger, please do not use the devices orally.
PLEASE READ CAREFULLY BEFORE USING
This digital thermometer provides a quick and highly accurate reading of an individual's body
temperature. The digital thermometer is intended to measure the human body's temperature in
regular mode orally, rectally or under the arm, and the device is reusable for clinical or home
use on people of all ages. To better understand its functions and to provide years of dependable
results, please read all instructions first.
This appliance conforms to the following standards:
ASTM E1112 Standard Specification for Electronic Thermometer for Intermittent Determination of
Patient Temperature,
ISO 80601-2-56 Medical electrical equipment —Part 2-56:Particular requirements for basic safety
and essential performance of clinical thermometers for body temperature measurement,
IEC 60601-1-11 Medical electrical equipment —Part 1-11: General requirements for basic safety and
essential performance –Collateral Standard: Requirements for medical electrical equipment and
medical electrical systems used in the home healthcare environment and complies with the
requirements of IEC 60601-1-2(EMC), AAMI/ANSI ES60601-1(Safety) standards. And the
manufacturer is ISO 13485 certified and FDA 510(k)K110776.
CONTENTS
1 Thermometer, 1 Owner's M anual, 1 Storage Case
PRODUCT ILLUSTRATION
Figure 1
Probe
PRECAUTION
*The performance of the device may be degraded should one or more of the following occur:
- Operation outside the manufacturer's stated temperature and humidity range.
- Storage outside the manufacturer's stated temperature and humidity range.
- Mechanical shock (for example, drop test).
- Patient temperature is below ambient temperature.
*Portable and mobile RF communications can affect the device. The device needs special pre-cautions
regarding EMC according to the EMC information provided in the accompany documents.
SYMBOL EXPLANATION
Direct Current
Type BF Applied Part
Consult Accompanying Documents
SPECIFICATIONS
Digital Thermometer (Not Predictive)
Type:
Measure Range: 90.0℉-109.9℉(32.0℃－42.9℃ ) (℃ / ℉c h osen b y m anufacturer )
Accuracy: ±0.2℉(±0.1℃) during 95.9℉~107.6℉(35.5℃~42.0℃) at
64.4℉~82.4℉(18℃~28℃ ) ambient operating range
±0.4℉(±0.2℃) for other measuring and ambient operating range
Procedures for determining the accuracy of the thermometer are
available upon request.
Operating mode: Direct Mode
Display: Liquid crystal display, 3 1/2 digits
Memory: For storing the last measured value
Battery: One 1.5 V DC. button battery (size LR41or SR41, UCC 392)
Battery life: Approx 200 hours
13.9cm x 2.2cm x 1.3cm (L x W x H)
Dimension:
Weight: Approx. 11 grams including battery
Ambient operating range: Temperature: 41℉～104℉ 5℃～40℃
Relative humidity: 15%~95%RH
Storage and transportation
Temperature: -4℉～131℉ -20℃~55℃
condition:
Relative humidity: 15%~95%RH
Ingress Protection Rating:
IP 27
Classification: Type BF
124mm
DIGITAL THERMOMETER
Model:KDT-1201
LCD Battery Cap
On/Off Button
Batch code
Manufacturerer
( )
( )
F C SWITCHABLE
0 / 0
Temperature readings are available in the Fahrenheit or Celsius scale (℉/℃; located in the upper right
corner of LCD.) With the unit off, press and hold the On/Off Button for approximately 4 seconds to
change the current setting.
DIRECTIONS
1. Press the On/Off Button next to LCD display. A tone will sound as the screen shows
followed by last recored temperature. After showing the self-test temperature, the thermometer is
now in the testing mode.
*Note: If the measured temperature is less than 90 ℉
temperature is higher than 109.9 or 42.9 , the LCD will display Hi. ℉ ℃
2. Position thermometer in desired location (mouth, rectum, or armpit.)
a) Oral Use: Place thermometer under tongue as indicated by
position shown in Figure 2. Close your mouth and breathe evenly
through the nose to prevent the measurement from being influenced
by inhaled/exhaled air. Normal temperature between 96.3
℃ ℃
(35.7 and 37.3 )
b) Rectal Use: Lubricate silver probe tip with petroleum jelly for easy insertion. Gently insert
sensor approximately 1cm (less than 1/2 ) into rectum. Normal temperature between 97.2 "
and 99.9 ℉ (36.2 ℃ and 37.7 ℃ ).
c) Armpit Use: Wipe armpit dry. Place probe in armpit and keep arm pressed firmly at side.
From a medical viewpoint, this method will always provide inaccurate readings, and should not
be used if precise measurements are required. Normal temperature between 95.4
(35.2 ℃ and 36.7 ℃ ).
3. The degree sign flashes throughout the testing process. When flashing stops an alarm will beep for
approximately 10 seconds. The measured reading will appear on the LCD simultaneously. The
minimum measurement time until the signaling tone (beep) must be maintained without exception. The
measurement continues even after the buzzer notification. The displayed temperature will not change
when thermometer is removed from its testing position.
*Note: Normally the buzzes are" Bi-Bi-Bi- B i-"; Alarm b eeps m ore ra pidly w hen te mperature
reaches 100 ℉ (37.8 ) or higher ,and t ℃ he buzzes are" Bi-Bi-Bi----- Bi-Bi-Bi------- Bi-Bi-Bi"
4. To prolong battery life, press the On/Off Button to turn unit off after testing is complete. If no action
is taken, the unit will automatically shut off after around10 minutes.
5. Store the thermometer in its protective case.
BATTERY REPLACEMENT
1. Replace battery when " " appears in the lower right corner of LCD display.
2. Pull battery cover off as shown in Figure 3.
3. Gently pull out plastic circuit board with battery chamber approximately 1 cm (slightly less than1/2
(See Figure 4)
4. Use pointed object such as a pen to remove old battery. Discard battery lawfully. Replace with new
1.5V DC button type LR41 or SR41,UCC392, or equivalent. Be sure battery is installed with
polarity facing up. (See Figure 5)
5. Slide battery chamber back into place and attach cover.
Figure 3 Figure 4
CLEANING AND DISINFECTION
wipe the thermometer with a soft clean cloth.
For stubborn stains, wipe the thermometer with a cloth that has been dampened with water or a
neutral detergent solution and then wring thoroughly. Finish by wiping with a soft dry cloth.
For disinfection, 70% Ethanol or Isopropyl alcohol can be used.
Observe the following to prevent damage to the thermometer.
-Do not use benzene, thinner, gasoline or other strong solvents to clean the thermometer.
-Do not attempt to disinfect the sensing section (tip) of the thermometer by immersing in
alcohol or in hot water (water over 122℉ 0℃ . (5
-Do not use ultrasonic washing to clean the thermometer.
FCC INFORMATION
Caution: Changes or modifications to this unit not expressly approved by the party responsible for
compliance could void the user authority to operate the equipment.
*Note:
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses, and can radiate radio
frequency energy. If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try and correct
the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the distance between the equipment and the receiver.
- Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
LIMITED WARRANTY
The thermometer is guaranteed for one year from the date of purchase. If the thermometer does not
function properly due to defective components or poor workmanship, we will repair or replace it free of
charge. All components are covered by this warranty excluding the battery. The warranty does not cover
damages to your thermometer due to improper handling.
of the sales receipt from the original retailer is required.
Disposal of this product and used batteries should be carried out
in accordance with the national regulations for the disposal of
electronic products.
Manufactured for Konquest Group Inc,
Email: info@konquestusa.com
www.konquestusa.com
Telephone: +1-833-KONQUEST (+1-833-566-7837)
Made in China
Document No. KDT-1201-V1
Version: English
Date of Issue: 2017.11
,
M
or 32 ℃ , the LCD will display Lo, if the measured
"√"
℉ and 99.1 ℉
Figure 2
℉
℉ and 98.1 ℉
".)
"+"
Figure 5
))
To obtain warranty service, an original or copy