Kubota M7040SU Operator's Manual page 30

12 OPERATING THE ENGINE
4. Place the PTO clutch control lever in
"OFF" position and position control
lever in "LOWEST" position.
(1) PTO clutch control lever
(2) Position control lever
5. Set the throttle lever to about 1/2 way.
(1) Hand throttle lever
(2) Foot throttle
6. Insert the key into the key switch and
turn it "ON".
"ON" "OFF"
(A) "DOWN"
"INCREASE"
"DECREASE"
"OFF" "ON"
C Check Easy Checker(TM) Lamps:
1. When the key is turned "ON", lamps (2) (3) should
come on. If trouble should occur at any location while
the engine is running,
corresponding to that location comes on.
2. Suppose that the engine coolant temperature is not
high enough yet. The glow plug indicator (4) also
comes on when the key is turned "ON" to preheat the
engine and goes off automatically when preheat is
completed.
Illumination time of indicator varies according to the
temperature of coolant.
3. The PTO clutch indicator (1) comes on while PTO
clutch control lever is engaged "ON" and goes off
when disengaged "OFF" it.
(1) PTO clutch indicator
(2) Electrical charge indicator
(3) Engine oil pressure indicator
A Daily checks with the Easy Checker(TM) only, are not
sufficient. Never fail to conduct daily checks carefully
by referring to Daily Check.
(See "DAILY CHECK" in "PERIODIC SERVICE"
section.)
"START"
the indicator lamp
(4) Glow plug indicator
(5) Fuel level indicator
(6) Key switch