1. Manuals
  2. Brands
  3. HME Manuals
  4. Security Sensors
  5. COMMUNICATOR COM6000
  6. Instructions

HME COMMUNICATOR COM6000 Instructions

Hide thumbs
1
2

Advertisement

Table of Contents

Prior to operation of the Wireless 6000 system, each Communicator must be registered for use
with a specific base station. The base station will then recognize all registered Communicators
when their power is on, differentiating between them and interfering transmissions from other
electronic equipment operating on similar frequencies. A maximum of 15 Communicators can
be registered.

Register each COMMUNICATOR

NOTE: Communicators must be within 6 feet (1.83 meters) of the base station while being
registered.
Be certain all Communicators to be registered are powered off and the base station power is
on. Other Communicators can be on or off.
Open the base station and press the registration button shown in Figure 1.
⎯ If no Communicators are powered on, the status light shown in Figure 1 will be blinking
red. If any Communicators are powered on, the status light will be on steady green.
⎯ After you press the registration button, the Communicator ID display will show a small
"o" for open and the status light will be blinking green.
Reset button
Figure 1. Registration buttons and indicators in base station
HM ELECTRONICS, INC.

REGISTRATION INSTRUCTIONS

®
Communicator ID display
Status light
Clear all registration button
Registration button
14110 Stowe Drive, Poway, CA 92064 USA • Phone: 1-800-848-4468 Fax: (858) 552-0172
COM6000
COMMUNICATOR
as follows:
®
HME# 400531
Rev A 1/5/04

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the COMMUNICATOR COM6000 and is the answer not in the manual?

Questions and answers

Related Manuals for HME COMMUNICATOR COM6000

Summary of Contents for HME COMMUNICATOR COM6000

  • Page 1 Status light Clear all registration button Registration button Reset button Figure 1. Registration buttons and indicators in base station 14110 Stowe Drive, Poway, CA 92064 USA • Phone: 1-800-848-4468 Fax: (858) 552-0172 HM ELECTRONICS, INC. HME# 400531 Rev A 1/5/04...
  • Page 2 Registration button green, indicating the active channel/lane. and repeat the registration procedure. ⎯ If registration fails again, call (in the USA) HME Customer Support at 1-800-848-4468 or (outside the USA) your local HME representative for assistance. Channel “A1” Channel “B” button button Channel “A2”...

Table of Contents