Perenio PECSS01 Manual

Dear Customer, thank you for choosing Perenio® products!
The Smoke Sensor is generally intended to timely detect smoke and
visible particles in the area of installation. It is used as part of the
Perenio Smart Building Management System upon detection by the
Control Gateway (CG).
BASIC FUNCTIONS AND KEY BENEFITS
For indoor installation only
Battery operated (DC 3V, 1500 mAh), high-decibel alarm (up to 85 dB/3 m),
iOS & Android smartphone compatibility, support of ZigBee 3.0, timely
detection of smoke, alarm testing/cutting off function, ultra-low power
consumption, low battery indication, tool-free installation option, compact
and stylish design.
PACKAGE CONTENTS:
PECSS01 Smoke Sensor (1 pc.), CR123A Battery (1 pc.), Screws with
Dowels (1 set), Reset Pin (1 pc.), 3M Mounting tape (1 pc.), Quick Start
Guide (1 pc.), Warranty Card (1 pc.).
INSTALLATION AND CONFIGURATION
1. Make sure that the Perenio® Control Gateway was pre-installed and
connected to the network through Wi-Fi/Ethernet.
NOTE. The Control Gateway may be purchased as a standalone device or as part of
the Perenio® Smart Kit.
2. Unpack the Smoke Sensor and unfasten its mounting bracket. Remove
the battery insulating strip to power on the device and fasten the Sensor
Doc Date: November 1, 2018
©Perenio IoT spol s r.o.
Version: 1.4.0
All Rights Reserved
1