Current COMPASS tradeselect CE Quick Start Manual

Ceiling & End Mounting
1. Connect input as shown in wiring diagram below and fasten canopy to J-box bracket.
2. Snap housing to canopy.
3. Secure faceplate to housing and remove the proper arrow as required.
Warning: Unused wires must be capped using enclosed wire nuts.
IMPORTANT
When relamping, only use lamps
specified in the exit sign. Using
other lamp types may result in
transformer damage or unsafe
conditions.
INSTALLATION
IMPORTANT SAFEGUARDS
When using electrical equipment, basic safety precautions should
always be followed including the following.
READ AND FOLLOW ALL SAFETY
INSTRUCTIONS
1. Do not use outdoors.
2. Do not mount near gas or electric heaters.
3. Use caution when handling batteries. Avoid possible shorting.
4. Equipment should be mounted in locations and at heights( MAX:8ft) where it will not be subject
to tampering by unauthorized personnel.
5. The use of accessory equipment not recommended by the manufacturer may cause an unsafe
condition.
6. Do not use this equipment for other than its intended use.
7. Before wiring to power supply, turn off electricity at fuse or circuit breaker.
8. Consult local building code for approved wiring and installation.
9. Installation and servicing should be performed by qualified personnel.
INSTALLER:
•SEE UNIT LABEL FOR ADDITIONAL MODEL SPECIFICATIONS
•SAVE THESE INSTRUCTIONS FOR USE BY OWNER/OCCUPANT
WARNING – This product contains chemicals known to the State of California to cause cancer, birth
defects and/or other reproductive harm. Thoroughly wash hands after installing, handling, cleaning,
or otherwise touching this product.
CE
LED Emergency Exit