Table of Contents
Advertisement
© Copyright 2016 ABB. All rights reserved.
Disassembly and assembly
Installing cartridge group
Fit the O-ring (42012).
Attach lifting gear to shackle of lifting device (90190) and turn com-
pressor casing (72000).
By hand, screw three press-off nuts (61090) onto bearing casing
studs, equally spaced around circumference, and up to end of thread.
Push compressor casing (72000) fully onto cartridge group and fasten
it using nuts (61037).
Secure three press-off nuts (61090) against compressor casing
(72000) by tightening them to specified torque. (See chapter Table of
tightening torques.)
Remove lifting device (90190).
Operation Manual / TPL67-C.. - TPL71-C..
8
8.7
Page 96
Advertisement
Table of Contents
