Whirlpool 8TWFW6620HW Use And Care Manual

Whirlpool 8TWFW6620HW Use And Care Manual

Front-loading automatic washer
Hide thumbs Also See for 8TWFW6620HW:

Advertisement

Quick Links

使用保養指南
適用型號: 8TWFW5620HW/8TWFW6620HW
Use and Care Guide
Applicable models: 8TWFW5620HW/8TWFW6620HW
滾筒洗衣機
Front-Loading Automatic Washer
W11316321B
If you have any problems or questions, visit us at www.whirlpool.com.tw.
www.whirlpool.com.tw
Designed to use only HE
High Efficiency detergents.
HE

Advertisement

Table of Contents
loading

Summary of Contents for Whirlpool 8TWFW6620HW

  • Page 1 使用保養指南 適用型號: 8TWFW5620HW/8TWFW6620HW Use and Care Guide Applicable models: 8TWFW5620HW/8TWFW6620HW 滾筒洗衣機 Front-Loading Automatic Washer www.whirlpool.com.tw If you have any problems or questions, visit us at www.whirlpool.com.tw. Designed to use only HE High Efficiency detergents. W11316321B...
  • Page 2: Table Of Contents

    洗衣機維護 ..............17 TROUBLESHOOTING ..........50 故障排除 ............... 21 ASSISTANCE AND SERVICE ...... Back Cover 幫助和服務 ..............30 產品規格: 8TWFW5620HW 8TWFW6620HW 120 V / 60 Hz 120 V / 60 Hz 17.0 kg 17.0 kg 0.03~0.7 MPa 0.03~0.7 MPa 500 W...
  • Page 3: Product Specifications

    107 kg External dimensions (H x W x D) 982 x 686 x 802 (mm) 982 x 686 x 802 (mm) NOTE: Actual specifications are as shown on the machine nameplate. For information on RoHs, please visit the official website: www.whirlpool.com.tw.
  • Page 4: Washer Safety

    WASHER SAFETY This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. If the power supply cord is damaged, it must be replaced by manufacturer or its service agent or similarly qualified person in order to avoid a hazard.
  • Page 5: Accessories

    The large drawer provides convenient storage. Accessories designed for your appliance: Customize your new washer and dryer with the following genuine Whirlpool accessories. For more information on options and ordering, call 0800-258-558 or visit us at: www.whirlpool.com.tw.
  • Page 6: Control Panel And Features

    CONTROL PANEL AND FEATURES NOTES: ■ Not all features and cycles are on all models. ■ If your model has a touch interface, the control panel features a sensitive surface that responds to a light touch of your finger. To ensure your selections are registered, touch the control panel with your fingertip, not your fingernail.
  • Page 7 UTILITY CYCLES Washing Clean Washer During the wash cycle, this will display to let you know Use this every 30 washes to keep the inside of your the cycle is in progress. washer fresh and clean. This cycle uses a higher water PreSoak level.
  • Page 8 DISPENSERS Load & Go Bulk Dispenser (only on some models – varies Single Load Dispenser Drawer by model) The single load dispenser drawer gives you the convenience The Load & Go bulk dispenser gives you the convenience of adding HE detergent, liquid chlorine bleach, and liquid fabric of not having to add the HE detergent to the wash load softener to the wash load at the proper time.
  • Page 9: Cycle Guide

    CYCLE GUIDE This washer has a unique user interface to help you select the best cycle for your load. The “What to Wash” “How to Wash” layout guides you to the optimal cycle in two easy steps: First determine what items are in the load that you are trying to wash. Use that to guide your “What to Wash” selection. Then determine how you want the washer to wash them and select the appropriate “How to Wash”...
  • Page 10 What Basic Settings Additional Options Temp Spin Soil Steam Clean Extra Rinse PreSoak Load & Go ✓ ✓ ✓ ✓ Delicates Normal Fast Medium Light Very Warm Fast Normal Warm Medium Heavy Cool Slow Cold ✓ ✓ ✓ ✓ Quick Fast Medium Light Very Warm...
  • Page 11 What Basic Settings Additional Options Temp Spin Soil Steam Clean Extra Rinse PreSoak Load & Go ✓ ✓ ✓ ✓ Whites Normal Fast Light Very Warm Medium Fast Normal Warm Medium Heavy Cool Slow Cold ✓ ✓ ✓ ✓ Quick Fast Light Very Warm...
  • Page 12: Choosing The Right Detergent

    What Basic Settings Additional Options Temp Spin Soil Steam Clean Extra Rinse PreSoak Load & Go ✓ ✓ ✓ ✓ Towels Normal Fast Light Very Warm Medium Fast Normal Warm Medium Heavy Cool Slow Cold ✓ ✓ ✓ ✓ Quick Fast Light Very Warm...
  • Page 13: Using The Dispensers

    USING THE DISPENSERS (varies by model) 1. For automatic dispensing, open the bulk dispenser drawer NOTES: using the handle at the base of the washer. For a single load, ■ A small amount of water may remain in the single load open the single load dispenser drawer at the top left corner dispenser from the previous wash cycle.
  • Page 14: Using Your Washer

    USING YOUR WASHER First wash cycle without laundry ■ Turn knits inside out to prevent pilling. Separate lint-takers Before washing clothes for the first time, set up the Load & Go from lint-givers. Synthetics, knits, and corduroy fabrics will bulk dispenser (on some models) or add detergent to the single- pick up lint from towels, rugs, and chenille fabrics.
  • Page 15 Add HE detergent Load laundry into washer Load & Go Bulk Dispenser (on some models) Liquid HE detergent bulk dispenser If the bulk dispenser already contains enough detergent to wash your load, simply choose the Load & Go option as described in Step 10.
  • Page 16 Touch POWER to turn on washer Add liquid fabric softener to single load dispenser, if desired Select a wash program/cycle Pour a measured amount of liquid fabric softener into liquid fabric softener compartment. Always follow manufacturer’s directions for correct amount of fabric softener, based on your load size.
  • Page 17 Touch and hold START/PAUSE Remove garments promptly to begin wash cycle after cycle is finished Touch and hold START/PAUSE for 3 seconds to start the wash cycle. To pause a cycle in progress, touch START/PAUSE once; then touch and hold again to continue the cycle. To cancel a cycle, touch and hold POWER and run Drain &...
  • Page 18: Washer Maintenance

    WASHER MAINTENANCE WATER INLET HOSES WASHER CARE (cont.) Replace inlet hoses after five years of use to reduce the risk iii. Let stand 5 minutes. of hose failure. Periodically inspect and replace inlet hoses iv. Wipe down area thoroughly with a dry cloth and let if bulges, kinks, cuts, wear, or leaks are found.
  • Page 19 WASHER CARE (cont.) CLEAN WASHER CYCLE REMINDER NOTE: Not all models have the Clean Washer with affresh c. Close the washer door and the dispenser drawer. cycle reminder light. d. Do not add any detergent or other chemicals to the The Clean Washer with affresh LED will flash at the end of a washer when following this procedure.
  • Page 20 TRANSPORTING YOUR WASHER CLEANING LOAD & GO CONTAINERS (on some models) 1. Shut off both water faucets. Disconnect and drain water inlet hoses. It is recommended that you rinse out the Load & Go 2. If washer will be moved during freezing weather, follow containers when refilling, when changing detergent types or “Winter Storage Care”...
  • Page 21 CLEANING THE DRAIN PUMP FILTER/ DRAINING RESIDUAL WATER (cont.) 4. Remove large clumps of lint by hand from the filter and place lint in a suitable waste container. Remove remaining residue from the filter by rinsing with water. CLEANING THE DRAIN PUMP FILTER/ DRAINING RESIDUAL WATER (on some models) NOTE: Perform the following procedure occasionally.
  • Page 22: Troubleshooting

    TROUBLESHOOTING First try the solutions suggested here or visit our website at www.whirlpool.com.tw. If you experience Possible Causes Solution Error Code Appears in Display (for 2- and 3-digit displays) Once any possible issues are corrected, touch POWER once to clear the code. Reselect and restart the cycle.
  • Page 23 TROUBLESHOOTING First try the solutions suggested here or visit our website at www.whirlpool.com.tw. If you experience Possible Causes Solution Error Code Appears in Display (for 2- and 3-digit displays) (cont.) “rL” Load detected in drum during Clean Remove items from washer drum and restart Clean Washer (remove load) Washer with affresh cycle.
  • Page 24 TROUBLESHOOTING First try the solutions suggested here or visit our website at www.whirlpool.com.tw. If you experience Possible Causes Solution Vibration or Off-Balance Vibration, rocking, Feet may not be in contact with the Front and rear feet must be in firm contact with floor, and or “walking”...
  • Page 25 TROUBLESHOOTING First try the solutions suggested here or visit our website at www.whirlpool.com.tw. If you experience Possible Causes Solution Water Leaks (cont.) Water or suds leaking from Not using HE detergent or using too Only use HE detergent. Suds from regular detergents door or rear of cabinet much HE detergent.
  • Page 26 TROUBLESHOOTING First try the solutions suggested here or visit our website at www.whirlpool.com.tw. If you experience Possible Causes Solution Washer Not Performing As Expected (cont.) Washer won’t run or fill; The load size is being sensed. After the load size is sensed, the estimated time based on washer stops working load size will be displayed and water will be added.
  • Page 27 TROUBLESHOOTING First try the solutions suggested here or visit our website at www.whirlpool.com.tw. If you experience Possible Causes Solution Washer Not Performing As Expected (cont.) Washer not draining/ Using cycles with a slower spin speed. Cycles with slower spin speeds remove less water than spinning;...
  • Page 28 TROUBLESHOOTING First try the solutions suggested here or visit our website at www.whirlpool.com.tw. If you experience Possible Causes Solution Washer Not Performing As Expected (cont.) Load not rinsed (cont.) Washer not loaded as Avoid tightly packing the washer. The washer will not rinse well if recommended.
  • Page 29 TROUBLESHOOTING First try the solutions suggested here or visit our website at www.whirlpool.com.tw. If you experience Possible Causes Solution Washer Not Performing As Expected (cont.) Not cleaning or Not using correct cycle for fabric type. Use a higher soil level setting and warmer wash temperature removing stains to improve cleaning.
  • Page 30 TROUBLESHOOTING First try the solutions suggested here or visit our website at www.whirlpool.com.tw. If you experience Possible Causes Solution Washer Not Performing As Expected (cont.) Gray whites, dingy colors Load not sorted properly. The transfer of dye can occur when mixing whites and colors in a load.
  • Page 31 TROUBLESHOOTING First try the solutions suggested here or visit our website at www.whirlpool.com.tw.. If you experience Possible Causes Solution Drying Results Clothes are not drying The load is too large and heavy to Separate the load to tumble freely. Loading drum a quarter full satisfactorily or drying dry quickly.
  • Page 32: Assistance And Service

    Before calling, please know the purchase date standards used to make each new Whirlpool product. and the complete model and serial number of To locate original factory-specified parts in your area: the washing machine.

This manual is also suitable for:

8twfw5620hw8twfw5620hw0

Table of Contents