Advertisement
INSTALLER'S GUIDE
5B. Checkout - For Units with a Honeywell W7212 Control, Only. See 5A for W7459
CHECKOUT AND TROUBLESHOOTING
Checkout requires a 9V battery, 620 ohm, 1.2K ohm, 5.6K ohm,
and 6.8K ohm resistors. Use Table 4 and Fig. 18 for checkout.
CAUTION
!
Equipment Damage Hazard.
Excessive force can damage potentiometer
controls.
Use a small screwdriver when adjusting enthalpy
changeover and minimum damper position controls.
Table 4. Checkout for W7212, W7213, W7214 Economizer Connected to Honeywell Actuator
Step
1.
CHECKOUT PREPARATION FOR ECONOMIZING ONLY
Disconnect power at TR and TR1
Disconnect devices at P and P1
Jumper P to P1 (defaults to on board MIN POS potentiometer).
Place 5.6K ohm resistor across T and T1 (Blue sleeve-provides input to
economizer that the MAT is between 50-55F).
Jumper TR to 1 (call for cooling from the thermostat).
W7212 only jumper TR to N (places economizer in occupied mode).
If connected, remove C7400 Enthalpy Sensor from terminals S
Connect 1.2K ohm, from 4074EJM Checkout Resistor kit, (purple sleeve)
across terminals S
O
Place 620 ohm resistor (white sleeve) across S
enthalpy lower than OA).
Set MIN POS and DCV MAX potentiometers fully CCW.
Turn DCV setpoint potentiometer mid position (this sets the DCV
ventilation at approximately 1000 ppm).
Turn exhaust potentiometer to mid position (motor will be approximately
50% open when the exhaust fan contacts make).
Set enthalpy potentiometer to D.
W7214 only Jumper TR to O.
Apply power (24 Vac) to terminals TR and TR1
16
Checkout Procedure
and + (makes OA enthalpy high).
R
1
DC VOLTMETER
+
S
C7400
+
1
INSERT DC VOLTMETER BETWEEN AQ AND AQ1 FOR
CHECKOUT AND TROUBLESHOOTING.
2
JUMPER USED FOR SINGLE ENTHALPY CONTROL.
Figure 18. Meter location for checkout and
troubleshooting (W7212 shown).
All LED are off; Exhaust Fan contacts are open
and +.
O
and + (makes return
W7212
EXH
N1
Set
N
2V
10V
EXH
P1
P
Min
Pos
T1
Open
T
DCV
Max
2V
10V
AQ1
DCV
AQ
DCV
Set
SO+
2V
10V
SO
Free
SR+
Cool
B
C
SR
A
D
2
620 OHM RESISTOR
Proper Response
18-HE39D8-13A-EN
M20612
Advertisement
