Table of Contents
Advertisement
1
Wheel bolt for alloy wheels
2
Wheel bolt for steel wheel
Clean the wheel and wheel hub contact surfa-
#
ces.
V V ehicles wit
ehicles with ultra
h ultrawide-base tir
wide-base tires:
#
the adapter for the more narrow spare wheel
on the wheel hub.
Slide the wheel which is to be installed onto
#
the wheel hub or the adapter for the spare
wheel and push it on.
V V ehicles wit
ehicles with light allo
h light alloy wheels
y wheels
Use the short wheel bolts intended for the
#
steel spare wheel, which are found in the vehi-
cle tool kit.
Screw in the wheel bolts until they are nger-
#
tight.
Wheels wit
Wheels with wheel nuts
h wheel nuts
Front wheels with wheel nut cover: press the
#
wheel nut cover onto the wheel nuts.
Screw in three wheel nuts over the xing discs
#
of the wheel nut cover.
Turn the wheel so that the wheel bolts are in
#
the middle of the holes.
Screw in the remaining wheel nuts.
#
Slightly tighten all the wheel nuts.
#
Lower ering t
Low
ing the v
he vehicle
ehicle a er
a er a wheel c
a wheel change
& W W ARNING
ARNING Risk of accident due to incor-
rect tightening torque
The wheels could come loose if the wheel bolts
or wheel nuts are not tightened to the prescri-
bed torque.
Ensure that the wheel bolts or wheel nuts
#
are tightened to the prescribed tighten-
ing torque.
If you are not sure, do not move the vehi-
#
cle. Contact a quali ed specialist work-
shop and have the tightening torque
checked immediately.
R R eq equir uirements:
ements:
The new wheel has been installed
R
(
/
Observe the notes on raising the vehicle
(
page 256).
/
V V ehicles wit
ehicles with r h rear wheel dr
Only use the middle rod and the pump lever rod
with the largest diameter for the jack as a lug
wrench extension. Only insert the middle rod on
the lug wrench, and always as far as it will go. Oth-
erwise, the rods could bend and deform so much
es: rst install
that they can no longer be used as pump levers for
the jack.
V V ehicles wit
ehicles with Super Single tir
spare wheel to the rear axle, do not exceed the
maximum speed of 34 mph (55 km/h) and the
maximum distance of 62 miles (100 km). Other-
wise, the transmission could be damaged due to
the di erent rotational speeds of the wheels.
Using the pump lever, slowly turn the drain
#
screw on the jack approximately one revolution
and carefully lower the vehicle.
Place the jack to one side.
#
Pull the rod with the smallest diameter o the
#
pump lever.
The shortened pump lever serves as a lug
wrench extension.
Starting with the middle rod, slide the lug
#
wrench extension as far as it will go onto the
lug wrench.
hange
Wheels and tires 259
page 258).
ear wheel drive
ive
h Super Single tires:
es: if you mount the
259
Advertisement
Table of Contents
