Table of Contents
Advertisement
Rebuild Procedures
8. Cam Spring Installation
1.
Insert the smaller cam spring through the larger
cam spring and align the flats of the spring loops
(Figure 18).
2.
Insert the clevis pin through the hole in the mounting tab
shown in Figure 18, with the head of the pin nearest
the fifth wheel top plate surface (Figure 19).
3.
With the flats of the cam springs nearest the fifth wheel
top plate surface, loop the larger cam spring end through
the hole in the clevis pin followed by the smaller spring
in the opposite direction, as illustrated (Figure 19).
4.
Insert the opposite ends of the cam springs through
the spring tab on the cam plate in the same manner
(Figure 18).
14
XL-FW20130RM-en-US Rev C · 2022-01-03 · Amendments and Errors Reserved · © SAF-HOLLAND, Inc., SAF-HOLLAND, HOLLAND, SAF,
and logos are trademarks of SAF-HOLLAND S.A., SAF-HOLLAND GmbH, and SAF-HOLLAND, Inc.
Figure 18
CAM PLATE
SPRING TAB
Figure 19
FLATS TOWARD TOP
PLATE SURFACE
HEAD OF PIN NEAREST
TOP PLATE SURFACE
MOUNTING TAB
CLEVIS PIN
FIFTH WHEEL TOP
PLATE SURFACE
Advertisement
Table of Contents
