Holland FW0E70-02 Operating Manual

Fifth wheel

Advertisement

Quick Links

WARNING
1.1 Identification of component parts . . . . . . . . . . . . . . . . . . . . . . . . . .
1.2 Important specifications . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
2.1 Pre-service inspection . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
2.2 Trailer coupling procedures . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
2.3 Trailer uncoupling procedures . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
3 Routine Inspection and Maintenance
3.1 As Needed Lubrication . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
3.2 Required Inspections and Adjustments . . . . . . . . . . . . . . . . . . . . . .
3.2.1 General fifth wheel inspection . . . . . . . . . . . . . . . . . . . . . . . . . . .
3.2.2 Inspection of locking mechanism . . . . . . . . . . . . . . . . . . . . . . . .
3.2.3 Lock adjustment procedure . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
XL-FW1083-01
You must read and understand the instructions in this manual
before operating your fifth wheel.
Failure to follow all of the important operating procedures
contained in these instructions may result in a dangerous condition
or cause a dangerous condition to develop.
These instructions apply to the proper operation of your fifth wheel
only. There are other important checks, inspections, and
procedures not listed here that are necessary, prudent, and/or
required by law.

Table of Contents

FWOE70-02
FW0E70-03
Fifth Wheel
Operating Manual
Page
2
2
3
4-5
5-6
6
7
7
8
1

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the FW0E70-02 and is the answer not in the manual?

Questions and answers

Summary of Contents for Holland FW0E70-02

  • Page 1 FWOE70-02 FW0E70-03 Fifth Wheel Operating Manual You must read and understand the instructions in this manual before operating your fifth wheel. Failure to follow all of the important operating procedures contained in these instructions may result in a dangerous condition or cause a dangerous condition to develop.
  • Page 2 170 kN 2" 30000 kg FW0E70-03-200 200 mm 36000 kg 184 kg 240 kN 3.5" FW0E70-02-200 200 mm 30000 kg 184 kg 170 kN 2" Holland Europe reserves the right, without prior notice, to change specifications and dimensions. XL-FW1083-01...
  • Page 3 2 Operating Instructions 2.1 Pre-service inspection Inspect the fifth Tighten loose fasteners with required torque wheel mounting Replace missing fasteners Repair/replace cracked components Make sure Lubricate the TILT coupling area fifth wheel-to- DOWN is flat, level and trailer contact clear of obstacles surface with grease and persons...
  • Page 4 2 Operating Instructions 2.2 Trailer coupling procedures Center kingpin Back tractor with fifth wheel close to trailer center and STOP. TRAILER (top) KINGPIN Chock trailer wheels Connect brake lines and light cord Support slack in lines to prevent interference Set trailer brakes WRONG Adjust trailer height so fifth wheel will lift trailer...
  • Page 5 2 Operating Instructions 2.2 Trailer coupling procedures (continued) NO GAP BETWEEN Visual inspection FIFTH WHEEL AND LOCK TRAILER PLATE Get out of tractor CLOSED Visually check that the fifth wheel is locked 1 - 2 - 3 SECONDARY HANDLE LOCK NOTCH ENGAGED BEHIND GUIDE OF CASTING SECONDARY LOCK HANDLE GUIDE...
  • Page 6 2.3 Trailer uncoupling procedure (continued) Extend landing Switch to gear until pads low gear just touch and crank an the ground additional Secure 4 - 8 turns handle HIGH GEAR! GEAR To Open To Open Unlock fifth wheel. Primary Lock Secondary Lock First open secondary lock: 1 grasp and pull inner...
  • Page 7 NOTE: Perform the following every three (3) months or 50,000 km, whichever comes first. Thoroughly steam clean all components before inspecting or adjusting. Verify the proper operation of the fifth wheel by locking and unlocking the fifth wheel locks using Holland Kingpin Lock Tester TF-TLN-1000 or TF-TLN-5001. UNLOCK...
  • Page 8 3 MAINTENANCE PROCEDURES 3.2 Required Inspections and Adjustments 3.2.3 Lock Adjustment Procedure Using Holland TF-TLN-5001 Lock Adjustment Tool, lock the fifth wheel and verify that it is closed as shown in Step 10 on Page 5. ROTATE TOOL Using a socket wrench with a 1/2" Allen hex...

This manual is also suitable for:

Fw0e70-03

Table of Contents