Advertisement
Undercarriage
Remove the machine from the package as shown
in illustration A.
Mount the wheels and the undercarriage as
shown in illustration B.
Before use
Always use the correct supply voltage: The
power supply voltage must match the information
quoted on the tool identification plate. Tools with
a rating of 230 V can also be connected to a
220 V supply.
The circuit must be protected by fuse with at least
10 A.
When operating the machine with a generator, a
unit with a power rating of 3.5 kVA/2800 W is nec-
essary (e. g. Bosch generator units G-3600-se-
ries).
An extension cable with a cross section that is too
small causes a distinct reduction in the perform-
ance capabilities of the machine. For cables to
25 m in length, a cross section of at least
2
3 x 1.5 mm
is required, for cables more than
25 m in length, the cross section must be at least
2
2.5 mm
.
Always completely unwind cable reels.
Always place the machine on firm level
ground. During operation, do not tilt or
move.
Remove any soil from root balls. Foreign bodies
like stones, glass, metals, fabrics, or plastics must
not enter the feed funnel since this could damage
the spiral cutting knives.
Initial Operation
2
The rotational direction switch 3 must be turned to
the right. The feed funnel 1 must be empty.
Switching on:
Set the on/off switch 2 to "I".
Switching off:
Set the on/off switch 2 to "O".
The motor will coast after switching off!
Rotational direction switch
The rotational direction switch 3 can only be oper-
ated when the machine is switched off. Always
wait for the machine to be idle before switching it
on again. When switching over with the motor
running, the direction of rotation remains un-
changed.
Right position ( ):
The spiral cutting knives pull in the material and
chop it.
Left position ( ):
The spiral cutting knives are operating in reverse
direction and jammed material is released.
Longer material standing out from the ma-
chine could lash out when being pulled in
by the knives! Please keep at safe distance!
Overload protection
Overloading (e. g. blocking up of the spiral cutting
knives) leads to a standstill of the machine after a
few seconds. After a short period, the machine
can be switched on again. Set the on/off switch 2
to "O" and then back to "I".
In case of blocking spiral cutting knives turn
the rotational direction switch 3 to the left
position ( ) before switching the machine
on again.
3
11
Advertisement
