Daily Use - Drying Only - AEG L7WEC842BI User Manual

36 www.aeg.com
• The indicator of the Inicio/Pausa
button goes off. The door locked
goes off.
The appliance continues to operate
with the anti-crease phase for
approximately 30 minutes or more if
Anti-crease option was set.
The anti-crease phase reduces
creasing.
You can remove the laundry before
the anti-crease phase is completed.
We recommend, for better results,
that you remove the laundry when the
phase is almost completed or
completed. The indicator
lit.

12. DAILY USE - DRYING ONLY

WARNING!
Refer to Safety chapters.
This appliance is an
automatic washer dryer.
12.1 Preparation to drying
1. Press the On/Off button for some
seconds to activate the appliance.
2. Load the laundry one item at a time.
3. Turn the programme dial to the
programme suitable for the items to
dry. The appliance defaults to the
washing only mode and the indicator
of the Modo - Lavar button is on.
4. Tap on the Modo - Secar button and
then on the Modo - Lavar button to
perform drying only. The indicator of
Modo - Secar button illuminates and
the indicator of Modo - Lavar button
goes off. The indicators
appear on the display and the
indicator
When drying a big amount
of laundry, to have good
drying performances, make
sure that the laundry itself is
not rolled up and that is
uniformly distributed in the
drum.
remains
and
disappears.
• Press the On/Off button for some
seconds to deactivate the appliance.
After some minutes from
the end of the
programme, the energy
saving function
deactivates the appliance
automatically.
1. Remove the laundry from the
appliance.
2. Make sure that the drum is empty.
After drying phase, clean the
drum, the seal and the inside
of the door with a wet cloth.
12.2 Drying - Automatic levels
1. Tap on the Auto Dry button
repeatedly until the display shows
the required dryness level. The
indicators in the display illuminate
accordingly:
a. Iron dry: for cotton items;
b. Cupboard dry: for cotton and
synthetic items;
c. Extra dry: for cotton items.
The display shows the drying
programme duration.
2. Touch the Inicio/Pausa button to
start the programme.
In the display the door locked
indicator comes on.
The display also shows the remaining
programme time.
12.3 Timed Drying
1. Tap on the Tiempo/Tempo sec.
button repeatedly to set the desired
time value (see the "Timed drying"
table the "Programmes" chapter).
The drying level indicator
and the indicator
Each time you tap on this button the
time value increases by 5 minutes. The
display shows the set new time value.
2. Touch the Inicio/Pausa to start the
programme.
goes off
comes on.