Daily Use - Washing & Drying - AEG L7WEC842BI User Manual

34 www.aeg.com
When you activate the
appliance again, the display
shows the end of the
previous programme. Turn
the programme dial to set a
new cycle.
2. Remove the laundry from the
appliance.
3. Make sure that the drum is empty.
4. Keep the door and the detergent
dispenser slightly ajar to prevent
mildew and odours.
5. Close the water tap.
10.13 Draining water out after
end of cycle
If you have chosen a programme or an
option that does not empty out the
water of the last rinse, the programme is
completed, but:
• The time area shows
display shows the door locked
• The indicator of the Inicio/Pausa
button starts flashing.
• The drum still turns at regular intervals
to prevent creases in the laundry.
• The door stays locked.
• You must drain the water to open the
door:
1. If necessary, touch the Centrifug.
button to decrease the spin speed
proposed by the appliance.
2. Press the Inicio/Pausa button: the
appliance drains the water and spins.
The option indicator Rinse Hold
disappears.
11. DAILY USE - WASHING & DRYING
WARNING!
Refer to Safety chapters.
This appliance is an
automatic washer dryer.
3. When the programme is completed
and the door locked indicator
goes off, you can open the door.
4. Press the On/Off button for a few
seconds to deactivate the appliance.
10.14 Stand-by function
The Stand-by function automatically
deactivates the appliance to reduce the
energy consumption when:
• You do not use the appliance for 5
minutes when no programme is
running.
Press the button On/Off to activate
the appliance again.
• 5 minutes after the end of the
washing programme.
and the
Press the On/Off button to activate
the appliance again.
.
The display shows the end of the last
programme.
Turn the programme dial to set a new
cycle.
If the dial is rotated to the "Reset"
position
turns off in 30 seconds.
11.1 Complete wash&dry
programme
Automatic Non-Stop
programme or programmes
Depending on the model, the appliance
may be equipped with one or more
NonStop 60min programmes, automatic
wash&dry programmes where it is not
necessary to set the Modo - Secar.
If you have selected No Spin
, the appliance will
only drain the water.
, the appliance automatically
If you set a programme or an
option that ends with water
in the drum, the Stand-by
function doesn't deactivate
the appliance to remind you
to drain the water.