Replacing an optical drive
This section provides instructions on how to remove and replace an optical drive.
1. Remove the computer cover. See "Removing the computer cover" on page 85.
2. Disconnect the signal and power cables from the rear of the optical drive.
3. Press the release button and remove the optical drive out the front of the
4. Remove the retainer bracket from the drive being replaced and install it on the
5. Slide the new optical drive into the bay from the front until it snaps into
6. Connect the signal and power cables to the drive.
7. Go to "Completing the FRU replacement" on page 120.
Attention
Do not open your computer or attempt any repair before reading and understanding the
"Important safety information" in the ThinkCentre Safety and Warranty Guide that came with
your computer. To obtain a copy of the ThinkCentre Safety and Warranty Guide, go to:
http://www.lenovo.com/support
computer.
new drive.
position.
Chapter 8. Replacing FRUs - Tamdhu Computers
109