Car Keys Express GMRM-4TZ1RE User Manual page 6

USER GUIDE
Q: The new remote won't pair to my car. What should I do?
A: If the EZ Installer doesn't pair the remote to your car, most likely, an incorrect
dial position was used. In this case, the EZ Installer will beep continuously
after you press the pairing button. Check the compatibility section on page
3 to confirm the correct dial position for your make, model, year, and button
configuration of your original remote. Remove the EZ Installer, turn the Ignition
off and try the pairing process from step 1. If the remote still won't pair, please
contact customer service at (888) 598-8910.
Q: The EZ Installer was unplugged during the pairing process. What should I do?
A: The EZ Installer must remain plugged into the on-board diagnostic (OBD)
port until pairing is complete. If the EZ Installer becomes unplugged during the
pairing process, turn the ignition to the OFF position, remove the key, and begin
the pairing process again.
FCC REGULATORY STATEMENTS
FCC ID: 2AOKM-GV1
47 CFR §15.19(a)(3) THIS DEVICE COMPLIES WITH PART 15 OF THE FCC
RULES. OPERATION IS SUBJECT TO THE FOLLOWING TWO CONDITIONS.
(1) THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE, AND (2)
THIS DEVICE MUST ACCEPT ANY INTERFERENCE RECEIVED, INCLUDING
INTERFERENCE THAT MAY CAUSE UNDESIRED OPERATION.
NOTE: Changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to operate the
equipment.
HELP
For help or assistance, please contact technical support at (888) 598-8910.
OTHER KEYS
Visit CarKeysExpress.com/store to find a variety of award-winning products, like
Universal Car Keys, Universal Car Remotes, and OEM keys and remotes.
6