Set User Password; Set Administrator Password; Setting, Changing, And Deleting A Password; Enabling Or Disabling A Device - Lenovo ThinkCentre A70z 1184 User Manual

v Be significantly different from your previous passwords

Set User Password

After you have set a User Password using the Set User Password option, the user
is prompted to type a valid User Password each time the computer is turned on.
The computer cannot be used until a valid User Password is typed in. For more
information on how to set a password, see "Setting, changing, and deleting a
password."

Set Administrator Password

The Set Administrator Password option enables you to set an Administrator
Password, which deters unauthorized users from changing configuration settings.
If you are responsible for maintaining the settings of several computers, you might
want to set an Administrator Password. For more information on how to set a
password, see "Setting, changing, and deleting a password."
After you have set an Administrator Password, a password prompt is displayed
each time you try to access the Setup Utility program. You cannot access the Setup
Utility program until a valid Administrator Password is typed in.
If you have set both the User Password and the Administrator Password, you can
type either password. However, to change any configuration settings, you must use
your Administrator Password.

Setting, changing, and deleting a password

To set, change, or delete a password, do the following:
1. Start the Setup Utility program. See "Starting the Setup Utility program" on
2. From the Setup Utility program main menu, select Security.
3. Follow the instructions displayed on the screen to set, change, or delete a

Enabling or disabling a device

This section provides instructions on how to enable or disable user access to the
devices connected to the SATA connectors on the system board.
USB Functions
SATA Controller
To enable or disable a device, do the following:
1. Start the Setup Utility program. See "Starting the Setup Utility program" on
2. From the Setup Utility program main menu, select Devices.
14
User Guide
page 13.
password.
Note: A password can be any combination of up to sixteen alphabetic and
numeric characters. For more information, see "Password considerations"
on page 13.
Use this option to enable or disable the USB connectors.
When this option is set to Disabled, all devices connected to the
SATA connectors (such as hard disk drives or the optical drive) are
disabled and cannot be accessed.
page 13.