Table of Contents
Advertisement
To install or replace a memory module, do the following:
1. Remove all media from the drives and turn off all attached devices and the
2. Remove the computer cover. See "Removing the computer cover" on page 16.
3. Lay the computer on its side for easier access to the system board.
4. Locate the memory slots on the system board. See "Locating parts on the
5. Remove all parts and disconnect all cables that might prevent your access to
6. If you are replacing a memory module, open the retaining clips and remove the
Figure 12. Removing the memory module
7. Open the retaining clips of the memory slot into which you want to install the
Figure 13. Opening the retaining clips of the memory slot
22
User Guide
computer. Then, disconnect all power cords from electrical outlets and
disconnect all cables that are connected to the computer.
system board" on page 12.
the memory slots.
old memory module that is currently installed. If you are installing a memory
module, go to step 7.
new memory module.
Advertisement
Table of Contents
