Table of Contents
Advertisement
en Troubleshooting
Fault
The spin result is not
satisfactory. The laun-
dry is too wet/too
damp.
Detergent residue on
the damp washing.
Detergent residue on
the dry laundry.
Water is leaking out at
the water inlet hose.
Water is leaking out at
the water outlet hose.
Odours have formed
in the appliance.
Fabric softener re-
mains in the detergent
drawer.
Water is leaking from
below the door.
46
Cause and troubleshooting
Note: Where possible, mix large and small items in
the drum. Different sized items of laundry distribute
themselves better during the spin cycle.
Start the Schleudern programme.
▶
Detergents may contain water-insoluble substances
that deposit on the laundry.
Start the Spülen programme.
▶
Detergents may contain water-insoluble substances
that deposit on the laundry.
Brush out the laundry after washing and drying.
▶
Water inlet hose is not correctly/securely connected.
Connect the water supply hose correctly.
1.
→ "Connecting the water inlet hose", Page 14
Tighten the screw connection.
2.
The water outlet hose is damaged.
Replace the damaged water outlet hose.
▶
Water outlet hose is not connected correctly.
Connect the water outlet hose correctly.
▶
→ "Water outlet connection types", Page 15
Humidity and detergent residue may promote the
formation of bacteria.
→ "Cleaning the drum", Page 34
▶
If you are not using the appliance, leave the door
▶
and detergent drawer open so that residual water
can evaporate.
The use of fabric softener is not supported for the se-
lected programme.
Before washing, check whether the use of fabric
▶
softener is supported for the selected programme.
→ "Programmes", Page 24
Dirt on the door or seal causes leaks.
Clean the door and the seal.
▶
Advertisement
Table of Contents
