Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for La Crosse Technology WS-9055TWC
Summary of Contents for La Crosse Technology WS-9055TWC
- Page 1 WS-9055U Wireless 433 MHz Weather Station Instruction Manual...
-
Page 2: Table Of Contents
Topic Page Quick Setup Inventory of Contents Detailed Setup Guide Battery Installation Setting the Time Features Minimum and Maximum Temperatures Resetting Minimum and Maximum Temperatures Adding additional remote 10-11 temperature sensors (optional) Weather Forecast Weather Icons 13-14 Tendency Arrow Mounting 15-16 Troubleshooting 16-18... -
Page 3: Quick Setup
QUICK SETUP Hint: Use good quality Alkaline Batteries and avoid rechargeable batteries. 1. Have the indoor temperature station and remote temperature sensor 3 to 5 feet apart. 2. Batteries should be out of both units for 10 minutes. 3. Place the batteries into the remote temperature sensor first then into the indoor temperature station. - Page 4 In this time the indoor temperature station and remote temperature sensor will start to talk to each other and the display will show both the indoor temperature and an outdoor temperature. If the indoor temperature station does not display both temperatures after the 15 minutes please retry the set up as stated above.
- Page 5 resistance. Your distance plus resistance should not exceed 80 ft. in a straight line. NOTE: Fog and mist will not harm your remote temperature sensor but direct rain must be avoided. To complete the set up of your indoor temperature station after the 15 minutes have passed please follow the steps in the detailed set up guide on page 8.
-
Page 6: Inventory Of Contents
INVENTORY OF CONTENTS The indoor weather station (Figure 1) The remote temperature sensor (TX6U) and mounting bracket. (Figure 2) 3 each, 1/2” Philips screws. One strip of double sided adhesive tape. Instruction Manual and Warranty Card. Figure 1 Figure 2 Holder... -
Page 7: Detailed Setup Guide
ADDITIONAL EQUIPMENT (not included) 1 Philips screwdriver. 2 Fresh AA Alkaline batteries. 2 Fresh AA Alkaline batteries DETAILED SETUP GUIDE Battery Installation Install 2 AA batteries in the remote temperature sensor. Make sure they do not spring free, or start-up problems may occur. -
Page 8: Setting The Time
Setting the time Press and hold the “SET” key for 4 seconds. The hour will flash. Press and release the “+” key to advance the hour. Press and release the “SET” key. The minute is flashing. Press and release the “+” key to advance the minutes. -
Page 9: Features Minimum And Maximum
FEATURES Minimum and Maximum Temperatures Press and release the “MIN/MAX” button, “MAX” appears between the indoor and remote temperatures. The recorded maximum indoor and remote temperature is displayed. Press and release the “MIN/MAX” button. “MIN” appears between the indoor and remote temperatures. -
Page 10: Adding Additional Remote
Resetting Min and Max Temperatures To reset both the minimum and maximum temperatures—press and hold the “MIN/MAX” button for 5 seconds. Adding Additional Remote Temperature Sensors (optional) The WS-9055U is able to receive signals from 3 different remote temperature sensors. Following are some brief instructions for the basic set-up of remote temperature sensor units with the WS-9055U. - Page 11 When setting up multiple remote temperature sensors, it is important to remove the batteries from all existing units in operation, then to insert batteries first into all the remote temperature sensors. Second install batteries into the indoor weather station and do not press any buttons for ten minutes.
-
Page 12: Weather Forecast
Weather Forecast The weather forecasting feature is estimated to be 75% accurate. The weather forecast is based solely upon the change of air pressure over time. The WS-9055U averages past air- pressure readings to provide an accurate forecast, creating a necessity to disregard all weather forecasting for 12-24 hours after the unit has been set-up, reset, or moved from one altitude to another (i.e. -
Page 13: Weather Icons
Weather Icons There are 3 possible weather icons that will be displayed in the FORECAST LCD: Sunny—indicates that the weather is expected to improve (not that the weather will be sunny). Sun with Clouds— indicates that the weather is expected to be fair (not that the weather will be sunny with clouds). -
Page 14: Tendency Arrow
The weather icons change when the unit detects a change in air pressure. The icons change in order, from “sunny” to “partly sunny” to “cloudy” or the reverse. It will not change from “sunny” directly to “rainy”, although it is possible for the change to occur quickly. -
Page 15: Mounting
MOUNTING Note: To achieve a true temperature reading, avoid mounting in direct sunlight. We recommend that you mount the remote temperature sensor on a North-facing wall. The sending range is 80ft; obstacles such as walls, concrete, and large metal objects will reduce the range. -
Page 16: Troubleshooting
use the table-stand all that is required is to place the indoor weather station in an appropriate location. To wall mount the indoor weather station first remove the table stand. Next insert an appropriate screw in your desired location. Using the integrated hanging hole on the back of the unit, slip indoor weather station over the screw and pull down to secure. - Page 17 Remove all batteries, reinsert into remote temperature sensor first, then into the indoor weather station. Place remote temperature sensor closer to the indoor weather station. Be sure all batteries are fresh. Place remote temperature sensor and indoor weather station in position so the straight-line signal is not passing through more than two or three walls.
-
Page 18: Maintenance And Care
case or radiant heat). Also, the much greater range of the outdoor temperature sensor requires a different calibration curve than the indoor range. Error is usually greater at the extreme ends of a range, making it harder to compare different ranges with different curves. -
Page 19: Specifications
• Opening the casings invalidates the warranty. Do not try to repair the unit. Contact La Crosse Technology repairs. SPECIFICATIONS Transmitting 433MHz Frequency Measuring Temperatures Indoor Weather 32°F to 156.2°F with 0.2 °F resolution Station (0°C to 69.0°C with 0.1°C resolution) -21.8 °F to 156.2°F Remote Temperature... - Page 20 Batteries—(Alkaline recommended) Remote 2 x AA, 1.5V Temperature Sensor Indoor Weather 2 x AA, 1.5V Station Dimensions: (L x W x H) Indoor Weather 5.5” x 3.2” x 1.25” Station (140 x 81 x 32 mm) Remote 1.57 x 0.85 x 5.00 in. Temperature (128 x 40 x 23 mm) Sensor...
-
Page 21: Warranty Information
WARRANTY INFORMATION La Crosse Technology, Ltd provides a 1-year limited warranty on this product against manufacturing defects in materials and workmanship. This limited warranty begins on the original date of purchase, is valid only on products purchased and used in North America and only to the original purchaser of this product. - Page 22 specified above. All replaced parts and products become the property of La Crosse Technology, Ltd and must be returned to La Crosse Technology, Ltd. Replacement parts and products assume the remaining original warranty, or ninety (90) days, whichever is longer. La Crosse Technology, Ltd will pay all expenses for labor and materials for all repairs covered by this warranty.
- Page 23 the carrier); (3) damage to, or deterioration of, any accessory or decorative surface; (4) damage resulting from failure to follow instructions contained in your owner’s manual; (5) damage resulting from the performance of repairs or alterations by someone other than an authorized La Crosse Technology, Ltd authorized service center;...
- Page 24 PRODUCT. THIS PRODUCT IS NOT TO BE USED FOR MEDICAL PURPOSES OR FOR PUBLIC INFORMATION. THIS PRODUCT IS NOT A TOY. KEEP OUT OF CHILDREN’S REACH. This warranty gives you specific legal rights. You may also have other rights specific to your State.
- Page 25 For warranty work, technical support, or information contact: La Crosse Technology, Ltd 190 Main Street La Crescent, MN 55947 Phone: 507.895.7095 Fax: 507.895.2820 e-mail: support@lacrossetechnology.com (warranty work) sales@lacrossetechnology.com (information on other products) web: www.lacrossetechnology.com Questions ? Please see instruction video at www.lacrossetechnology.info/9055...
- Page 26 FCC DISCLAIMER This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference. (2) This device must accept any interference received, including interference that may cause undesired operation.
Need help?
Do you have a question about the WS-9055TWC and is the answer not in the manual?
Questions and answers