Table of Contents
Advertisement
INSTALLATION
POWER SUPPLY
(Refer to Figure 2)
1. The high voltage power supply MUST be located at least
6.1 m (20 feet) from the spraying operation. If a spray
booth is used, the power supply may be located 1.5 m
(5 feet) from the nearest opening and outside the booth
.
2. If a line cord is used instead of a permanent conduit
connection, ensure the ground lead is present on the
plug. Ensure that the electrical outlet is properly wired
by using the circuit tester (20868-00). Attach the green
ground wire to a proven, true earth ground (i.e., water
pipe or electrical conduit).
3. After the power supply is grounded to a suitable earth
ground, the high voltage cable may be connected. Prior
to connection of the high voltage, place a small amount
of LSCH0009-00 dielectric grease around the end of the
tube as shown in Figure 3 below.
APPLY LSCH0009-00 ON THIS AREA PRIOR TO USE
Figure 3: LSCH0009-00 Dielectric Application
AH-13-01-R8 (09/2022)
1
2
7
9
Figure 4: Equipment Installation Diagram
Return To Contents
4. Attach the female nut of the high voltage cable to the
male threads of the connection of the power supply.
† Where the applicator is to be used without a booth,
the power supply must located a minimum of 6.1 m (20
feet) from the target being sprayed.
† The target Earth Ground and Power Supply earth
ground must be separate earth ground connections.
† Any fluid hose that is are user supplied must be rated
for the maximum pressures used for this applicator.
FLUID HOSE
(Refer to Figure 4)
Install the fluid filter to the applicator, then to the fluid delivery
hose. Attach one end of the fluid hose to the adapter.
This adapter has a 3/8-18 NPSM (F) for attachment to a
suitable fluid source. To meet various length requirements,
the hose fitting on one end has not been attached.
Figure 5 illustrates the assembly procedure for attaching
the loose fitting.
5
6
4
14 / 55
WARNING
!
8
3
www.carlisleft.com
EN
Advertisement
Table of Contents
