La Crosse Technology WS-8017U-MAH Instruction Manual page 6

•
use of the foldout table stands, or
•
wall mounting
FOLDOUT TABLE STAND
The Foldout table stand legs are located on the backside, at the
lower corners, and on both sides of the battery cover. The hinges
are towards the edges of the Atomic Clock, and the ends (with no
hinge) need to be folded out towards the edge. Once the Foldout
table stands are extended, place the Atomic Clock in an appropriate
location.
WALL MOUNTING
1) Using a straightedge, horizontally space at 2-3/4 of an inch (70 mm) three
screw positions on a wall.
2) Install three mounting screws (not included) into a wall within transmission
range—leaving approximately 3/16 of an inch (5mm) extended from the wall.
3) Place the Atomic Clock onto the screws, using the hanging holes on the
backside. Gently pull the Atomic Clock down to lock the screws into place.
Note:
Always ensure that the Atomic Clock locks onto the screws before releasing.
POSITIONING THE OUTDOOR TEMPERATURE TRANSMITTER
The Outdoor Temperature transmitter can be mounted in two ways:
•
with the use of screws, or using the adhesive tape.
MOUNTING WITH SCREWS
1) Remove the mounting bracket from the Outdoor Temperature Transmitter.
2) Place the mounting bracket over the desired location. Through the three
screw holes of the bracket, mark the mounting surface with a pencil.
3) Where marked, start the screw holes into mounting surface.
4) Screw mounting bracket onto the mounting surface. Ensure that the
screws are flush with the bracket.
MOUNTING WITH ADHESIVE TAPE
1) With a nonabrasive solution, clean and dry the back of the mounting
bracket and the mounting surface to ensure a secure hold. The
mounting surface should be smooth and flat.
2) Remove the protective strip from one side of the tape. Adhere the
tape to the designated area on the back of the mounting bracket.
3) Remove the protective strip from the other side of the tape. Position
the Outdoor Temperature transmitter in the desired location,
ensuring that the Atomic Clock can receive the signal.