__ 8. Select Start a service tool and press Enter.
__ 9. Select Operator panel functions and press Enter.
__ 10. Select the function key to power off the system (F10).
__ 11. Press Enter to confirm that you want to power down.
__ 12. Power off and unplug attached workstations and printers.
Connecting the Operations Console cable
__ 1. Remove the system unit back cover.
__ 2. Attach the disposable wrist strap to prevent electrostatic discharge from
__ 3. If you have a 270 System Unit, locate position C07. See "PCI card locations"
__ 4. If you have a 820 System Unit, locate position C06. See "PCI card locations"
4
AS/400e 270 or 820: Upgrading the System Unit from Twinaxial Console to Operations Console (Feature 5544)
__ a. Place your hand near the bottom of the back cover and lift up and
out.
__ b. Attention: If removing side cover while powered on, errors may
occur due to electromagnetic interference.
damaging a device. Attach the adhesive part of the foil to an unpainted
surface.
on page 13 for more information.
on page 13 for more information.